702669
22
Zoom out
Zoom in
Previous page
1/31
Next page
Pagina 22 Handleiding TDA 2001 Terminal Adapter
TDA 2001 II /V020206 – 15/02/1999
6. BIJLAGE A - STORINGEN VERHELPEN
STORING MOGELIJKE OORZAAK OPLOSSING
Er is geen zgn.
‘Moving worm’
in het
LED-display te zien.
De voedingsspanning is te laag of
niet aanwezig.
Controleer de voedingsspanning! Deze
moet tussen 11,5 Vdc en 14,5 Vdc
liggen.
De
‘Moving worm’
in
het display beweegt niet
meer.
Onbekend. Maak de TDA 2001 spanningsloos en
breng de spanning vervolgens weer aan.
Er is geen kiestoon
1. Er is geen ‘Moving worm’ of de
‘Moving worm’ beweegt met
halve snelheid.
2. De ISDN lijn is niet O.K.
3. De alarmoverdrager of
telefoontoestel is niet goed
aangesloten
4. De ISDN lijn was even weg en
is nu weer hersteld.
5. Er is wel lijnspanning. De TDA
2001 is aangesloten op een
Point-to-Point configuratie maar
staat op Multipoint.
1. Controleer de voedingsspanning
2. Controleer de ISDN S0-bus met
behulp van een ander ISDN apparaat.
3. Controleer of de alarmoverdrager
goed is aangesloten (zie fig. 2.1) en
sluit het telefoontoestel correct aan
(tip & ring)
4. Dit kan maximaal 5,5 min. duren mits
de ISDN lijn O.K. is. Na een reset zal
de kiestoon echter gelijk herstellen
mits de ISDN lijn O.K. is en alles
correct is aangesloten.
5. Stel de TDA 2001 via programmeerlijn
[2] in op Point-to-Multipoint.
Er is geen signaal op de
interne S0’-bus en het
relais is aan en schakelt
iedere 5 minuten kort
uit en vervolgens weer
aan.
Er is een storing aanwezig op de
interne S0’-bus ! De TDA 2001
probeert iedere 5 minuten of de
storing al is opgelost.
Controleer de bekabeling van de interne
S0’-bus op gekruiste aders en eventuele
kortsluitingen.
De
‘Moving Worm’
beweegt met halve
snelheid en er is geen
kiestoon.
De voedingsspanning is lager dan
9 Vdc!
Controleer de voedingsspanning. Deze
moet in ieder geval hoger zijn dan 11,5
Vdc!
De S0’-bus wordt bij
ieder gesprek
afgebroken
1. Programmeerlijn 4 heeft optie 4
of 5.
2. Er is een fout in de bekabeling
1. De TDA 2001 werkt correct. Wacht 90
sec. of 300 sec. en probeer opnieuw.
Er zijn voortdurend 2 B-kanalen bezet
en programmeerlijn [6] staat op 2.
2. Controleer de bekabeling. Test
opnieuw als de TDA 2001 alleen is
aangesloten op de NT1.
Bij aansluiting van een
terminal op de S0’-bus
valt de communicatie
met de terminal weg.
De S0’-bus wordt
afgeschakeld.
De signalen Rx en Tx zijn niet in
fase aangesloten. Rx is verwisseld
met Tx of RX+ is verwisseld met
RX-.
Controleer de bekabeling op
verwisseling van aders!
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech TDA 2001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech TDA 2001 in the language / languages: Dutch as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Aritech TDA 2001

Aritech TDA 2001 Installation Guide - Dutch - 47 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info