702727
7
Zoom out
Zoom in
Previous page
1/12
Next page
Installation
Copyright 1996 WARNING-Opto-Elektronik GmbH & Co Produktions KG
changes reserved
6
B-board for receiver
5
4
3
2
1
Heater 12V AC/DC
Heater 12V AC/DC
Armed/Disarmed
Disqualification
Alarm memory
A connection for the heater is only available at the B-board provided that it has been equipped with a
disqualification.
heaterboard for transmitter/receiver
2
1
Heater 12V AC/DC
Heater 12V AC/DC
The heating board can be installed in both the transmitter and receiver.
3.2.1 Wiring diagram
distributor
Transmitter
to central
control unit
Receiver
Connection for
earth potential
Connection
for screen
(clamp 3)
Screen on both
sides to be
connected with „-„
Screen to be
connected with
earth potential
1.
2.
3.
survey of wiring diagram
Transmitter/Receiver
screen
(connected
internally
w
ith „-“
+ - S
distributor
To central
control unit
to receive
r
to transmitter
screen
connection to supply voltage and
screening
The following items must be considered for the wiring of a VdS-installation:
1. Connect screen of the supply line leading to the distributor with earth potential.
2. The screen of the supply lines must be connected from the distributor to the devices
from both sides with minus potential. Never connect the screen with earth potential.
3. The housings are to be connected with earth potential.
4. No signals are allowed to be transmitted over the screens.
When inductive load is required at the output an additional protecting circuit must be provided i.e. RC-
component or diode.
3.3 Installation of the equipment
The devices are to be installed on a solid foundation in vertical order. The swivelling optic reduces the
necessity of putting the devices on a common optical axis. For to open the single units untie the screws
at the housing ends and remove the cover carefully. When closing the devices put on the cover
carefully and fasten screws carefully again.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech DO560 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech DO560 in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info