557702
13
Zoom out
Zoom in
Previous page
1/24
Next page
User Manual for CD72/95/15003
Page 13
7. Press the
Accept
key again.
!
!!
!
Normal Set
!
!!
!
Normal Set
"
Area 2 is arming. If programmed, the buzzer for the area
will begin.
Area 2 Arming
Beeeep
You must exit the protected area by the designated exit
route.
Leave Now
Area 1 Armed
Both areas are now armed.
Area 2 Armed
Enter Area No.
TUE 23 APR 07.41
A
RMING A SPLIT SYSTEM WITH OPEN ZONES
When arming (switching on) the alarm, you may get the message
‘Open Zone(s)’
along with a list of
the zones in the premises which have not yet been closed. You should close these zones and then
retry arming the alarm. However, occasionally you may not be able to close an open zone because, for
example, a door lock or magnetic contact may be malfunctioning. You can then exclude this open zone
from the system (called inhibiting a zone). A split system lets you control open zones in specific areas
of the premises.
Only use this exclusion option when absolutely necessary as any inhibiting of zones will reduce the
security level of your system.
Although you can exclude an open zone when the tamper alarm has been triggered (identified by the
letter ‘T’ in front of the open zone listed), you will not be able to arm the system until the tamper alarm
has been rectified.
As explained in section “Arming a split system,” a split system can be programmed to have two
different standby message displays, that is the message you see when you approach the keypad, and
two different messages immediately after entering your code into the keypad. The instructions below
use the displays “Time/Date” and “Area
[
number
]
armed.”
If your code lets you access more than one security area, you can select one of them to arm.
1. Go to the keypad. The current day, date and time are
displayed. An example is shown.
TUE 23 APR 08.21
2. Press the key
0
and then enter your code. A ‘*’
appears in the display for every key you press. Use the
0
key to cancel an incorrect entry and to restart a new entry
of the code.
Enter Code
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech CD 7203 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech CD 7203 in the language / languages: English as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info