702280
7
Zoom out
Zoom in
Previous page
1/28
Next page
ATS125x 4-Door DGP Installation Manual 3
Battery replacement
This product contains one or more sealed, rechargeable, BS-type lead-acid batteries.
These are a maintenance-free, leakproof, long-life batteries that should not be
removed under normal circumstances. Because removing a battery may affect the
product’s configuration settings or trigger an alarm, only a qualified installer should
remove the batteries.
To remove a battery, do the following:
1. Make sure that your product settings allow you to open the cover without starting
the tamper alarm.
2. Switch off the mains power, if necessary, and remove the cover.
3. Disconnect the battery, sliding the product's wires off the wire connectors. Note
that, depending on the battery model, the connectors may be located differently.
4. Remove the battery from the holder.
5. For proper recycling, dispose of all batteries as required by local ordinances or
regulations.
See the specifications for your product or contact technical support for information
on replacement batteries.
Important notes on mounting
Mount the unit using screws or bolts through the four mounting holes in the base.
Ensure that the unit is mounted on a flat, solid, vertical surface so that the base will
not flex or warp when the mounting screws or bolts are tightened.
Allow 50 mm clearance between equipment enclosures mounted side-by-side, and
25 mm between an enclosure and the sidewall.
Only use units in a clean environment and not in humid air.
LEDs
Table 3: ATS125x LEDs
LED Description
RST OFF: The microprocessor is functioning normally.
ON: The system is in the reset state.
Rx1 Flashing LED indicates polling data is being received from the ATS control panel on the
system databus.
Tx1 Flashing LED indicates the 4-door DGP is replying to polling from the ATS control panel on
the system databus.
Rx Flashing LED indicates remote units (readers and interfaces) replying to polling.
Tx Flashing LED indicates the 4-door DGP is polling remote units (readers and interfaces) on the
ATS125x local databus. The Tx LED should always be active.
L1 L4 Indicates the Unlock Relay is active.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech ATS1250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech ATS1250 in the language / languages: English as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Aritech ATS1250

Aritech ATS1250 Additional guide - Dutch - 72 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info