455092
14
Zoom out
Zoom in
Previous page
1/70
Next page
15
555
mm
475
mm
55
mm
Fastening Clamps - Assembly Diagram
Clamp Position for Clamp Position for
H=20mm top H=30mm top
Front
Clamp Position for
H=40mm top Back
N.B: Use the clamps contained in the "accessory kit."
f) In the event the cooktop is not installed above a built-in
oven, a wood panel must be inserted as insulation. This
panel must be placed at least 20 mm from the bottom of
the cooktop itself.
Important: When installing the cooktop above a built-in oven,
the oven should be placed on two wooden strips; in the case
of a joining cabinet surface, remember to leave a space of at
least 45 x 560 mm at the back.
560 mm.
45 mm.
When installing the cooktop above a built-in oven without
forced ventilation, ensure that there are air inlets and outlets
for ventilating the interior of the cabinet adequately.
Gas Connection for Cooktop
The cooktop should be connected to the gas supply by an
authorized installer. During installation of this product it is
essential to fit an approved gas tap to isolate the supply from
the appliance for the convenience of any subsequent removal
or servicing. Connection of the appliance to the gas mains
or liquid gas tanks must be carried out according to the safety
standards currently in force, and only after it is ascertained
that it is suitable for the type of gas to be used. If not, follow
the instructions indicated in the section entitled, “Adapting
the Cooktop for Different Types of Gas”. If the cooktop is to
be connected to tanks containing liquid gas, use pressure
regulators that comply with current safety standards.
Important: To insure that the appliance operates safety, the
gas is regulated correctly and your appliance lasts over time,
make sure that gas pressure levels comply with the
indications given in Table 1, “Nozzle and Burner
Specifications”.
Gas Connection to Non-flexible Pipe
(copper or steel)
Connection to the gas source must be done in such a way
as to not create any stress points at any part of the appliance.
The appliance is fitted with an adjustable, "L" shaped
connector and a gasket for the attachment to the gas supply.
Should this connector have to be turned, the gasket must be
replaced (supplied with the appliance).
The gas feed connector to the appliance is a threaded, male
1/2" connector for round gas pipe.
Gas Connection to Flexible Steel Pipe
The gas feed connector to the appliance is a threaded, male
1/2" connector for round gas pipe. Only use pipes, tubes
and gaskets that comply with current safety codes. The
maximum length of the flexible pipes must not exceed 2000
mm. Once the connection has been made, ensure that the
flexible metal tube does not touch any moving parts and is
not crushed.
Check the Seal
Once the appliance has been installed, make sure all the
connections are properly sealed, using a soapy water
solution. Never use a flame.
Electrical Connection
The cooktops fitted with a tripolar electrical supply cord are
designed to be be used with alternating current according to
the indications on the rating plate located under the cooktop.
The earthing wire can be identified by its yellow-green colour.
In the case of installation over a built-in electric oven, the
electrical connections for the cooktop and oven should be
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston PO 740 ES IX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston PO 740 ES IX in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 2,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info