566471
30
Zoom out
Zoom in
Previous page
1/104
Next page
Heat pump water heater – GENERAL INFORMATION
28
EN 255-3 ; EN 60335-1 ; EN/IEC 60335-2-21 ; EN 60335-2-40 ; EN 55014-1 ; EN 61000-3-2 ; EN 61000-3-3 ; EN
50366.
1.5 Packaging and supplied accessories
The device consists of an external unit (heat pump) and an internal one (water heater), this could be anchored to a
wooden pallet (only 300L model), Both units are protected by polystyrene buffers and cardboard on the outside; all the
materials are recyclable and eco-compatible.
The following accessories are included:
- Shielded probe connection cable between units;
- Connection pipe for condensation water of the external unit;
- Drainage pipe for condensation water;
- Wall hole protection;
- Instruction manual and warranty documents;
- One 3/4” dielectric coupling.
- Rubber grommets and cable clips with screws.
1.6 Transport and handling
Upon delivery of the product, check that the latter has not been damaged during transport and that no signs of
damage appear on the packaging. In the event of damages, immediately notify any claims to the forwarder.
WARNING! Absolutely imperative that the external unit is handled and stored in an upright position, with the
aim of ensuring adequate provision of oil inside the cooling system and avoid damage to the compressor.
The indoor unit can be moved both vertically and horizontally.
The packaged unit can be moved by hand or with forklift trucks, taking care to respect the directions above. It is
recommended to keep the product in its original packaging until you install it in the selected area, particularly in the
case of a construction site.
After unpacking, check for accuracy and completeness of the supply. In case of non-compliance, please contact the
seller, taking care to make a communication within the law.
WARNING! Keep the packaging elements out of the reach of children, as they are potentially dangerous.
When transporting or handling the appliance after the initial start-up, observe the aforementioned indication
concerning the allowed tilt angle of the external unit, and ensure that all water has been drained from the tank. If the
original packaging missing, provide an adequate protection for the appliance to prevent any damages, for which the
manufacturer shall not be held liable.
1.7 Identification of the appliance
The main information for identifying the appliance is contained on the adhesive data plate located on the water heater
casing.
Internal unit
28
isuali
label
Descri
ption
A
model
B
tank capacity
C
serial no.
D
power supply voltage.
F
requency.
M
aximum absorbed power
E
max./min.
P
ressure of the refrigeration circui
t
F
tank protection
G
absorbed power
heating element mode
H
marks and symbols
I
thermal power yielded in heat pump mode
L
max./min.
P
ower in heat pump mode
M
type of refrigerant and charge
N
maximum tank pressure
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston NUOS 200 SPLIT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston NUOS 200 SPLIT in the language / languages: English, Dutch, French, Italian as an attachment in your email.

The manual is 2,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info