Manual Ariston Nevis (page 42 of 160) (English, Dutch, French, Italian, Portuguese, Spanish)

663711

Zoom out

Zoom in

1/160

42 /

2. PIPING AND CONNECTIONS

WARNING:

- Only use piping speciﬁ cally designed for ACR air conditioning units.

- Protect all connection cables and pipes in order to prevent their being damaged.

- Never use pipes with a thickness of under 0.8 mm.

- The appliance must be installed in full compliance with national system regulations.

- During the installation process, the refrigeration system should be connected ﬁ rst, followed by the electricity

supply. In the event of replacement, proceed in the reverse order.

WARNING:

- Do not drink the condensation water (personal injury from poi-

soning).

- Position the condensation drain pipe in such a way as to allow

for the correct downward ﬂ ow of water in dedicated areas, and

to prevent any inconvenience or damage to people, things, ani-

mals, plants and structures.

- Use manual tools and equipment that are suitable for the in-

tended purpose.

2.1 Connecting the refrigeration piping

The piping can be positioned in diﬀ erent directions as indicated by

numbers 1, 2, 3, 4 in the adjacent ﬁ gure. In case of conﬁ guration “1”,“3”

remove plastic cover. Turn the pipes in the direction of the hole in the

wall, taking care not to constrict them in any way, and tape the re-

frigeration system piping, condensation drain pipe and electrical wir-

ing together with electric (insulating) tape, keeping the condensation

drain pipe at the bottom so that the water can ﬂ ow freely.

2.2 Draining the condensation from the internal unit

The proper draining of condensation from the internal unit is funda-

mental for a good installation.

1. Keep the condensation drain pipe (diameter 16,5 mm) at the bottom

of the hole in the wall.

2. Make sure the condensation drain pipe has a continuous gradient

of approximately 3 cm per metre.

3. Do not include any traps in the condensation discharge piping.

4. Do not immerse the free end of the condensation drain pipe in wa-

ter and do not leave it in the vicinity of places emanating unpleas-

ant odours.

5. When the installation is complete, before switching on the appli-

ance, make sure the condensation drain pipe works properly by

pouring some water into the condensation drip water tray situated

inside the internal unit.

NOTE: The condensation drain tube is pre-installed on the same side

as the refrigeration pipes. The internal unit, however, has a further

housing, sealed by a rubber plug, on the opposite side to the refrig-

eration pipes. It is, therefore, possible to swap the positions of the

drain tube and the rubber plug, making sure that the plug is correctly

ﬁ tted to avoid water leakage

2.3 Draining the condensation from the external unit

The condensation or water that forms in the external unit during op-

eration in heating mode can be removed via the drain pipe ﬁ tting. In-

stallation: fasten the drain pipe ﬁ tting (diameter 16 mm) to the hole on

the bottom of the unit, as illustrated in the adjacent diagram. Connect

the condensation drain pipe to the drain pipe ﬁ tting and ensure the

other end of the pipe is ducted into a suitable drain.

PIPING INSULATION

CONDENSATION

DISCHARGE PIPE

REFRIGERATION

SYSTEM PIPING

REFRIGERATION

SYSTEM PIPING

SIGNAL CABLE

INSULATING

SHEATH

YES NO NO

2,5 kW

3,5 kW

RUBBER

CAP

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston Nevis in the language / languages: English, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5,69 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston Nevis Manual

Product: