Priming the water circuit
! Before starting the machine after long periods of
inactivity, if the water tank has been completely
emptied, it is essential to prime the machine circuit.
Moreover the circuit must be primed every time the
following is displayed:
1. To prime the circuit,
direct the steam spout
over the drip tray.
Place a cup or suitable
container below the
steam spout and press
the key.
2. Wait until the water
runs smoothly out of the
steam spout.
To interrupt, press the
key.
After the above operations have been completed the
machine is ready for use.
To dispense coffee, hot water or steam and for proper
use of the machine, carefully follow the instructions that
are provided.
Aqua Prima filter (where installed)
The Aqua Prima filter purifies the water used in the
preparation of coffee.
Its properties reduce the hardness of water and remove
the unpleasant taste of chlorine.
The Aqua Prima filter may be installed at any time.
Installing the Aqua Prima filter
1. Open the front panel
and remove the water
tank.
Empty the tank of any
water.
2. Remove the filter
packaging and set the
calendar to the current
month.
! Refer to the notes for
using the filter below.
3. Insert the filter into the
tank. The reference mark
and the groove should
coincide. Press down
completely.
Fill the tank with fresh
drinking water and
replace in the machine.
Close the front panel.
Dispense all the water in
the tank into a container.
Afterwards fill the tank
again with water.
! Program the machine
for use with the filter
(see programming). The
machine informs the user when it is time to replace the
filter.
! The Aqua Prima filter must always be removed before
running the descaling cycle.
Regulating water hardness
Regulate the machine to the right degree of water hard-
ness that you will use.
According to this setting, the machine advises when it is
necessary to run a descaling cycle.
Read the sections on “Water hardness” in “Program
-
ming” to regulate hardness.