454770
13
Zoom out
Zoom in
Previous page
1/42
Next page
14
- If the power supply cord has been damaged or needs to be
replaced;
- If the appliance breaks down or functions poorly; ask for original
spare parts.
It is a good idea to do the following:
- Only use the appliance to cook food, nothing else;
- Check the soundness of the appliance after it has been
unpacked;
- disconnect the appliance from the electrical mains if it is not
functioning properly and before cleaning or performing
maintenance;
- When the appliance is not used for an extended period of
time, cut off the supply of power and close the gas cock (if
present);
- Use cooking gloves to place cookware in the oven or when
removing it;
- Always grasp the oven door in the centre because the ends
may be hot due to the escape of hot air;
- Make sure that the control knobs are on the “•”/”o” setting
when the appliance is not in use;
- Cut the power supply chord after disconnecting it from the
mains when you decide not to use the appliance any longer.
The manufacturer will not be held liable for any damages that
might arise out of incorrect installation or improper, incorrect
or unreasonable use of the appliance.
Installation
Important: The power supply to the appliance must be
cut off before any adjustments or maintenance work is
done on it.
Installation of Built-in Ovens
In order to insure that the built-in appliance functions
properly, the cabinet containing it must be appropriate.
The figure below gives the dimensions of the cutout for
installation under the counter or in a cabinet wall unit.
595 mm.
595 mm.
20 mm.
543 mm.
5 mm.
567 mm.
23 mm.
593 mm.
45 mm.
558 mm.
595 mm.
595 mm.
20 mm.
543 mm.
5 mm.
567 mm.
23 mm.
575-585 mm.
558 mm.
595 mm.
45 mm.
min.
45 mm.
min.
In order to ensure adequate ventilation, the back panel of
the cabinet must be removed. Installing the oven so that it
rests on two strips of wood is preferable.
In the case where the oven rests on a continuous, flat
surface, there must be an aperture of at least 45 x 560
mm.
560 mm.
45 mm.
The panels of the adjacent cabinets must be made of
heat resistant material. In particular, cabinets with a veneer
exterior must be assembled with glues able to withstand
temperatures of up to 100°C.
In compliance with current safety standards, contact with
the electrical parts of the oven must not be possible once
it has been installed.
All parts which ensure safe operation of the appliance must
not be able to be removed without the use of a tool.
Fastening the Oven to the Cabinet
1. Position the "A" brackets so that they are flush against
the oven support strips (B).
2. Position the cleats (C) on the "A" brackets as shown in
the figure so that the thickness of the sides of the
cabinet, indicated on the cleat, is facing you.
3. Fasten the brackets and the cleats to the edge of the
side of the cabinet using the "D" screws.
4. Fasten the oven to the cabinet using the screws and
plastic washers (E).
D
A
B
D
D
18
16
18
16
18
16
18
16
18
18
18
18
C
C
C
E
E
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston FM 54 T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston FM 54 T in the language / languages: English, Dutch, French, Italian, Spanish, Finnish as an attachment in your email.

The manual is 2,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info