665482
29
Zoom out
Zoom in
Previous page
1/30
Next page
EG
29
Legionella is a bacteria that under certain conditions can be present in any water system.
The proliferation of this bacteria depends on many factors and it nds the best conditions to survive between 20ºC to
45ºC. That’s why, even though each Country has a different local regulation about Legionella prevention, all of them re-
quire to heat water over than 50ºC.
Anti legionella cycle is a special operation mode performed by Emix. The goal of this mode is to heat the water of the
tank. In this way, all bacteria that may have been inside the water would be killed.
The antilegionella cycle is closed when:
• the water temperature is above 65°C, or
• the water temperature is above 50°C for a variable period of time depending on the temperature itself.
If within 72 hours (3 days) none of the above conditions have been satised, the cycle is activated.
During the cycle the YELLOW LED lights up.
The connected electrical heaters can be used during anti legionella cycle.
During the cycle, by water temperature trend analysis, if the software understands that there is not enough energy using
only the heat pump, the rst electrical element will be switched on automatically. All the other electrical elements will be
switched on every 120’ checking water temperature trend up to reach the necessary conditions to close the cycle. If there
is a ow switch connected, the cycle time will be reduced according to the amount of water taken.
If after 8 hours none of the above conditions occurred, the cycle will continue, but the YELLOW LED will begin ashing
with low frequency to alert the end user.
NOTE: The antilegionella cycle is fundamental for the health of people; it is normally completed due to thermodynamic
energy, however, we can not exclude that in unfavorable atmospheric conditions, the heat pump is unable to complete
by itself the cycle. For this reason it is obligatory to connect the heater / the heaters; in case you do not connect at least
one electrical heater, under certain operating conditions, it may happen that the legionella cycle will not be closed, a
condition for which our company does not assume any responsibility.
ANTI-LEGIONELLA CYCLE
AUTO-DIAGNOSIS TABLE
Error Cause LED
BLUE YELLOW RED
1 Error on outdoor unit F
3 Communication error with outdoor unit F F F
4 Sensor REFRIGERANT OUT damaged or
disconnected
F F
5 Sensor H2O IN damaged or disconnected F F
6 Sensor H2O OUT damaged or disconnected F
7 Circulation pump error or lack of water ow F F
8 Electrical heaters not set F
F flashing LED
LED ON
LED OFF
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Emix at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Emix in the language / languages: English, German, French, Italian, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo Emix

Argo Emix User Manual - English - 29 pages

Argo Emix User Manual - German - 29 pages

Argo Emix User Manual - French - 29 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info