805048
10
Zoom out
Zoom in
Previous page
1/23
Next page
33V 05/23
In this mode, each time the POWER button is pressed the unit switches off, the appliance saves the settings
and retains them when it is switched on again.
The humidity % adjustment range is 35-80%.
The fan speed cannot be adjusted.
NOTE: the air conditioner does not cool the room when operating as a dehumidier. When the appliance is
used as a dehumidier, the exible pipe must not be connected. For maximum dehumidication efciency, leave
the rear discharge attachment free to discharge directly into the environment. The dehumidication mode is
recommended during autumn and winter. If used during summer, it is best to leave the exible pipe attached so
that the hot air is discharged towards the outside rather than into the room. During dehumidication, continuous
drainage should be implemented (see the next chapter, “HOW TO ELIMINATE CONDENSATE”).
4. FAN MODE (FAN)
Press the MODE button to select ventilation until the corresponding icon appears.
In this mode, the fan speed can be adjusted.
The temperature cannot be adjusted.
This appliance automatically vaporizes the condensate in cooling mode. When the air conditioner works in Cooling
mode, it is not necessary to have continuous drainage of the condensate; only in particular climatic conditions in which
the humidity rate in the air is very high can water deposit inside the unit.
In Heating mode the condensate is not vaporized automatically, it will therefore be necessary to empty the internal
tank periodically. Alternatively, the drainage can be arranged from the lower hole located on the back of the unit, the
internal condensate drainage will be intermittent.
When the internal tank is full, the air conditioner goes into stand-by mode within about 10 seconds, and the display
will show the message "P1", while the icon will light up on the control panel, signaling that it has been lled.
The buttons on the control panel are not active and the appliance stops working.
The operation LED ring located on the front of the unit lights up red.
To restore the unit, empty the tank.
Cooling and Heating
Make sure that, when the unit works in cooling and heating mode, the rubber closing cap that closes the drain hole
located at the bottom on the back is correctly positioned.
To empty the tank, turn off the air conditioner and unplug it. Remove the cap from the rear drain hole, connect the small
condensate drain tube, which is supplied, and place the other end of the tube above a normal drain.
Make sure the hose is free from twists and bends. The pipe must have a descending trend. Close the drain with the
cap and resume using the air conditioner.
Dehumidication
Warning: when using the air conditioner in dehumidication mode, it is advisable to always set up continuous
drainage to ensure maximum dehumidication efciency. Connect one end of the PVC tubing (provided) to the top
drain hole and the other end above a drain.
HOW TO ELIMINATE CONDENSATE
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Argo Einar Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Argo Einar Plus in the language / languages: English as an attachment in your email.

The manual is 5.43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Argo Einar Plus

Argo Einar Plus User Manual - German - 23 pages

Argo Einar Plus User Manual - Italian - 23 pages

Argo Einar Plus User Manual - Spanish - 23 pages

Argo Einar Plus User Manual - Spanish - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info