578808

Arcam P777 Manual

8
Zoom out
Zoom in
Previous page
1/50
Next page
E-8
operation
Front panel control
e front panel has a single control: a centrally located
power on/o button.
POWER
Switches the unit on and o. Note that the modules are
turned on individually to stagger the surge created when
a powerful amplier is switched on (i.e., it provides a
‘so start’). is reduces the surge current drawn from
the domestic power supply.
Status LEDs
A separate LED indicates the status of each of the seven
channels of the P777.
e LEDs cycle through red, orange, then green to
indicate the status from powered-up (initialised),
stabilised and active respectively.
All LEDs are o in standby mode.
Operating procedure
Once the relevant connections have been made, the
P777 can be switched on using the central button on the
front panel.
Switching on
It is recommended that you switch on your pre-amplier
or controller before powering up the power amplier.
Normal powering up is indicated by the following
sequence of front panel LED indicators:
1. On pressing the power switch, all LEDs turn red.
2. Aer a short delay (about half-a-second), the
centre LED turns amber.
3. e LEDs continue turning amber from the
centre to the edges in pairs, at about one second
intervals.
4. e centre LED turns green and a relay ‘click’ is
heard.
5. e LEDs continue turning green from the centre
to the edges in pairs, along with relay ‘clicks’, at
about one second intervals.
In the unlikely event that the LEDs do not follow this
sequence when the unit is powered up, or they behave
abnormally at any time during use, then refer to the
‘Fault status indicators’ table on page 10 to discover why
the amplier is in protection mode.
Switching o
To shut down, switch the power amplier o rst,
followed by the pre-amplier or controller.
is eliminates the chance of any ‘thumps’ or power
spikes being fed through to the power amplier and
potentially causing damage to the system.
MULTICHANNEL POWER AMPLIFIER
1 2 3 4 5 6 7
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam P777 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam P777 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info