578801
10
Zoom out
Zoom in
Previous page
1/16
Next page
10
Using the remote control
NOTE
Remember to install the two AAA batteries supplied
before trying to use your remote control.
Do not place anything in front of the FMJ badge on
the top left of the CD player (where the IR receiver
is located), or the remote control may not work.
CR-389 REMOTE CONTROL
The CR-389 remote control gives access to all functions available on
the front panel of the A32. It also has controls to operate Arcam CD
players, AM/FM tuners and DAB tuners. The remote control transmits
Philips RC-5 type codes.
FM DAB
PROG DISP
RPT
MODE BAND
1-9 2-10 3-11
FM
DAB
SEL
TUNER
CR-389
CD
AMPLIFIER
VCRDVD TA PEAV
TUNERCDAUXPHONO
ENTER
SP1
SP2
DISP
MENU DISP
4-12
5-13 6-14 7-15 8-16
TUNER
These buttons are used to control tuner functions.
Note that the
FM/DAB lights indicate into which mode
you are switching the remote control. The lights only
illuminate for five seconds to conserve battery power.
If neither light is illuminated this does not mean that the remote
control is not working!
(UP and DOWN)
Perform the same function as the buttons on the front
panel (see page 6).
SELECT
Performs same function as the SELECT button on the front
panel. It allows you to use the remotes volume switch in the
same way you use the control dial on the front panel to
adjust various amplifier settings (see page 8).
Note that pressing + corresponds to turning the
Control knob clockwise, to anticlockwise.
ENTER
Performs the same function as the ENTER button on the front
panel (see page 8).
Source selection buttons
These operate in the same way as the source selectors on the
front panel of your integrated amplifier.
Power/Standby
Toggles the amplifier between standby mode and full power
mode. The power indicator light next to the power button on
the front panel is red if the amplifier is in standby, amber while
the amplifier is powering up (this only takes a few seconds) and
green when the amplifier is powered up.
SP1 and SP2
These buttons allow you to select and deselect the main (SP1)
and secondary (SP2) sets of speakers attached to your amplifier
(see page 6).
DISP (display)
Cycles through the settings Bright, Off and Dim. Turning the
display Off generally gives a slight improvement in sound quality.
Volume and (mute)
Press + to increase volume or to decrease the output volume
of the amplifier.
Press
to mute the speaker connections and preamp outputs.
Both tape outputs and the headphone socket remain active.
Mute is disabled either by pressing
again, or by adjusting
the volume.
You can use the remotes volume control in conjunction with
the
SELECT button to adjust balance, tone and amplifier settings.
CD controls
These offer basic control of Arcam CD players
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam FMJ P35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam FMJ P35 in the language / languages: English as an attachment in your email.

The manual is 0,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info