159827
9
Zoom out
Zoom in
Previous page
1/36
Next page
MS250
9
POWER
6
Press this button to switch on the MS250. The power indicator light changes from red
to green. From power-on, the MS250 will take about 30 seconds to initialise; a start-up
message is displayed on the front panel.
When powered-on, press this button for a second time to switch the unit off. The
MS250 takes a few seconds to shut down. To avoid risk of data loss, do not remove
power from the unit during this period.
LOAD
2
To load a CD, press LOAD (or OPEN on the remote control). The CD tray opens to accept 12cm or 8cm
discs. Place the CD in the tray with the label facing uppermost. Press
LOAD again (or press PLAY, or
gently push the tray in 5mm) to close the tray. After a few seconds, if the CD has been found in the
online database, the track names appear on the display.
Music control keys
3
These keys can be used to control CDs and stored music.
Play/Pause: Press
4
/
;
to play the current music selection. Press again to pause the music. If the
music is paused, pressing
4
/
;
again will resume the music from the point where it was paused.
Stop: Press
< to stop the current music selection. Pressing
4
/
;
after the music has been stopped will
resume playing at the start of the current track.
Search forwards/backwards: Press
8
or
7
on the front-panel or remote control to search fast
forward or backwards. The following speeds for fast search are available: x2, x4, x8, x16 and x32. Press
the button repeatedly to cycle through the different speeds. To resume normal playback speed (and play
the CD or stored music), press
4
/
;
.
Skip track: To start a CD with a track other than the rst, press
/ or 0 to locate the desired track.
To select another track at any time during play, press
/ or 0.
Menu navigation keys
4
These keys allow navigation through the MS250 menu system – they match the cursor keys on the
remote control. Use the up-down-left-right keys to move the menu highlight to the item of interest, then
press
OK to open or select the highlighted item. The HOME key returns you to the top-level menu.
DISPLAY
5
This key changes the brightness of the display. Press repeatedly to reduce the brightness in steps from
full brightness to off. Press once more to restore to full brightness.
ZONE
7
Press the Zone button to select the zone you wish to view or control. There are four output zones, which
in a typical installation will be routed to different rooms in the house. The zone number is shown on the
display along with the audio settings for that zone. You can route different audio sources to different
zones. For example, you can play a stored CD in one zone and Internet radio in another zone at the
same time.
USB connector
1
The front panel USB connector is in addition to the two USB connectors on the back panel of the MS250.
It allows easier access to the MS250 for playing music or transferring music les from portable music
sources. You can also attach a USB keyboard here to make text editing easier.
Front-panel controls
NOTE
To put the unit into stand-by, press
the power button on the remote
control or front panel. The front
panel display dims and shows the
time and date.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Arcam fmj ms250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Arcam fmj ms250 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info