AV9
E-27
Using Zone 2
Introduction
Zone 2 provides the option for the occupants of the master bedroom, children’s room or
kitchen to view or listen to a different source at a different volume level from the main
zone (zone 1).
If a video feed is provided to Zone 2, then the following menu, unique to a Zone 2 IR
receiver, can be called up using the MENU button on a CR80 remote control.
Control via Zone 2 menu
Vol: Shows present volume being used in Zone 2, which can be adjusted from here.
Audio Input: This shows the current audio input source selected. The current audio
input can be changed when this line is highlighted, using the
34
navigation buttons.
Changing the audio input also changes the video input to the same setting.
Video Input: This shows the current video input source selected. The current video
input can be changed when this line is highlighted, using the
34
navigation buttons.
Changing the video input does not change the audio input, so it is possible to watch a different input
from the one you are listening to.
Record to Tape: Allows any analogue input to be directed to the tape output, independently of the
input being listened to. You cannot select tape as a record source: if allowed, this would cause feedback
through the tape recorder.
Record to VCR: Allows any analogue audio input together with Composite or S-video input to be
directed to the VCR output. The selection is independent of the input that is currently being listened to or
watched.
You cannot select ‘VCR’ as a record source: if allowed this would cause feedback through the VCR.
Zone 1 Status: Shows the user status of zone 1 (the main zone). The status can be On (i.e., being
used) or Off (i.e., in standby mode).
Zone 1 Volume: Shows and allows adjustment of the volume in zone 1 (the main zone). This can be
locked out with the ‘Zone 1 Control’ line of ‘Zone 2 Settings’ in the Setup Menu.
Zone 1 Audio: Shows and allows adjustment of the audio selection in zone 1 (the main zone). This can
be locked out with the ‘Zone 1 Control’ line of ‘Zone 2 Settings’ in the Setup Menu.
Zone 1 Video: Shows and allows adjustment of the video selection in zone 1 (the main zone). This can
be locked out with the ‘Zone 1 Control’ line of ‘Zone 2 Settings’ in the Setup Menu.
