807551
8
Zoom out
Zoom in
Previous page
1/24
Next page
8
on the type plate of the device.
Do not trap the power cable and protect it
from sharp edges, damp, heat or oil. The
power cable of the unit cannot be replaced.
In the event that the cable is damaged, the
unit must be disposed of.
Do not operate the device or immediately
pull the plug if it is damaged or you suspect
it may be defective. In this case, contact our
technicians.
Pull the plug when the device is not in use.
Keep packaging materials, especially plastic
and plastic bags, away from children. Risk of
suocation.
Remove all plastic from the device before
use.
Lay the mains cable in such a way that you
are not hindered by it, and no one is able to
accidentally pull it.
Disconnect the battery charger from the
power supply after the charging process is
complete.
Keep the charger in a place that cannot
be accessed by children or unauthorised
persons.
Never operate the device in the vicinity of
ammable materials or in an environment
prone to explosion.
Always wear suitable working clothes,
protective gloves and goggles. Battery acid
is corrosive! Immediately and thoroughly
wash o any splashed acid and consult a
doctor, if necessary. If battery acid gets into
the eyes, immediately rinse under running
water for at least 10 minutes and consult a
doctor.
Do not cover the charger, this may lead to
overheating and result in damages. Never
set the charger up for operation on a surface
that is insulating (e.g. polystyrene). There is
a risk of heat built up!
If you wish to charge a vehicle battery
when it is not installed, place it in a well-
ventilated area.
If you wish to charge a vehicle battery in the
installed state, rst park the vehicle safely,
put on the parking break and switch o the
ignition. Disconnect the battery from the
on-board power network for your vehicle,
remove the positive (+) cable from the
battery. To do this, read the manual of your
vehicle or ask your specialist workshop.
When pulling the mains cable out of the
socket, only hold the plug.
Never expose the charger to the vicinity of
re, heat and extensive temperatures over
+40°C.
Store these instructions carefully and, if
necessary, pass them on to other users.
5. EXPLANATION OF SYMBOLS
Complies with EC directives
Labelled electrical products may not be
disposed of in the household waste
Read the operating instructions
Devices with this symbol may only be opera-
ted in the house (dry environment)
Corresponds to the requirements of § 21 of the
German Product Safety Law (Produktsicher-
heitsgesetz)
6. OPERATING INSTRUCTIONS
6.1 OVERVIEW
Before using the device make sure that you
have read the operating instructions for the
battery and the vehicle and you have unders-
tood all of the safety precautions.
1 Display
2 Selection switch for battery type
3 Selection switch for display
4 Selection switch for charging mode/jump start
5 Mains connection cable
6 Battery connector cable positive (+), (red)
7 Battery connector cable negative (-), (black)
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Apa 16631 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Apa 16631 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2.43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info