Apply hand-brake fully. There are 4 different hand-brake systems. With all four systems please observe the following:
Hand-Brake lever with gas strut (Fig 3)
Enure handbrake is fully applied (as highlighted). This will ensure that the gas strut will automatically reapply the wheel brakes if trailer starts to roll
backwards.
To release: Press the hand-brake push button fully home and firmly press the handbrake lever back into the off position (handbrake horizontal)
Attention: Do not put any presssure on the brake rod when the hand brake is opend (OPEN) because in this case hand brake or the
parkingbrake is not functioning.
Servicing:
Every 10 000 – 15 000 km or every 12 months:
Lubricate/grease all sliding and moving parts of the overrun device as shown in Fig. 7.
Recommended lubricant: General purpose grease to DIN 51825 KTA 3KA
Troubleshooting
Fault Cause Elimination
Poor Breking
Overrun shaft/linkages tight
Overrun shaft corroded
Damage to body housing
Grease transmission system and
all moving parts
Brake overheating during towing
Hand-brake not fully released
Wheel fouls brake rod
Release hand-brake
Check transmission system
operates smoothly. Check
overrun lever moves freely
Slacken locking handle and
repossition accembly correctly
Handbrake force low Gas strut defective Replace gas strut
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Anssems GT at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Anssems GT in the language / languages: English as an attachment in your email.
The manual is 6,42 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
