764159
9
Zoom out
Zoom in
Previous page
1/12
Next page
9
TROUBLESHOOTING
Problem Solution
Your smoke alarm
does not sound during
testing
If testing immediately after first activating the alarm or replacing the batteries,
you should allow a few seconds for the alarm to settle before testing.
Make sure you push the centre of the test button firmly.
If the alarm has been recently fitted and it still fails to self test
then contact Technical Support on: 0800 141 2561 or e-mail:
technicalsupport@sprue.com.
The operating light
remains steadily on
or off
Inspect for obvious damage.
Check the unit contains the recommended battery type and that it is properly
connected.
If in doubt, contact Technical Support on: 0800 141 2561 or e-mail:
technicalsupport@sprue.com.
The alarm beeps twice
every 45 seconds
This indicates a fault with the alarm.
Inspect for obvious damage.
Check the unit contains the recommended battery type and that it is properly
connected.
If in doubt, contact Technical Support on: 0800 141 2561 or e-mail:
technicalsupport@sprue.com.
Your smoke alarm
beeps every 45 seconds
This indicates that the battery is low and needs replacing.
Refer to the ‘Battery Replacement’ section of this manual.
WARNING: If there is any question as to
the cause of an alarm, always assume that
this is due to an actual fire and follow your
fire emergency plans. Do not assume the
alarm is a nuisance alarm.
BATTERY
REPLACEMENT
Your alarm requires two AAA (LR03)
alkaline batteries. Under normal use, the
batteries should last approximately one
year.
Low Battery Warning - alarm beeps
every 45 seconds for up to 30 days
when the battery needs replacing.
Low Battery Waming Silence - low
battery warnings often start at night.
Silence the audible warning for ten
hours by pressing the test button,
thus avoiding removing the batteries.
Change the batteries the following
day. The red LED flashes twice every
45 seconds to remind you that the low
battery warning has been silenced.
IMPORTANT: Test alarm using test facility
whenever batteries are replaced.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AngelEye SA700-AE-UK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AngelEye SA700-AE-UK in the language / languages: English as an attachment in your email.

The manual is 1,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info