764158
6
Zoom out
Zoom in
Previous page
1/20
Next page
6
accommodation which is in a separate
room from the combustion appliance(s)
should also contain an alarm, located
in accordance with previous advice in
this section.
It is not always possible to find an
optimum location for an apparatus,
for example, a small caravan may not
have suitable vertical surfaces available.
Nevertheless, when fitting an apparatus
in such situations, the two most important
considerations when selecting an
appropriate location are:
Not mounting the apparatus directly
above a source of heat or steam; and
Mounting the apparatus at a distance
of 1 – 3 m from the nearest edge of
the potential source.
INSTALLATION
NOTE: This apparatus should be installed
by a competent person who feels able to
install it according to the instructions.
Firstly write the installation date on
your alarm in the area provided. We
recommend that your alarm is installed
on the wall.
To mount on a wall or ceiling:
Please ensure that you use the screws
provided, as they were chosen specifically
for use with this product. Use template
below for guidance on marking hole
positions. Drill holes into the wall. Insert
the plastic wall plugs. Screw in the screws.
Ensure screws are protruding from the
wall by 3mm to allow the alarm to slot
onto screws.
To place on a shelf:
The base of the alarm has been designed
to allow it to stand freely on a shelf.
BATTERY
REPLACEMENT
a If the alarm is already wall or ceiling
mounted then unhook it from the
mounting screws.
b Remove the battery cover located on
the back of the alarm.
c Replace the batteries with 2 x approved
1.5 volt AA size alkaline batteries (see
page 14 for recommended batteries),
making sure the batteries are the
correct way round. Use of batteries
other than those recommended by
Sprue Safety Products Ltd may have
a detrimental effect on the alarm’s
operation. Replace the battery
cover and return the alarm to its
original position.
90mm
Drill hole spacing
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AngelEye CO-FA-AE-9B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AngelEye CO-FA-AE-9B in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info