681995
6
Zoom out
Zoom in
Previous page
1/62
Next page
16.13 Discard ‘dead’ batteries as soon as possible
since ‘dead’ batteries are more likely to leak in a
product. If a battery has leaked or vented, it should
be replaced immediately using protective gloves.
16.14 DO NOT store this product, or the batteries
provided with or identified for use with this
product, in high-temperature areas.
WARNING
17. (North America Only)
17.1 Warning: Changes or modifications to this
equipment not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
17.2 NOTE: This equipment has been tested
and found to comply with part 15 of the FCC
Rules and the Industry Canada license-exempt
RSS standard(s). These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
17.3 However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment OFF
and ON, the user is encouraged to try to correct
the interference by one or more of the following
measures:
Reorient or relocate the receiving
antenna.
Increase the separation between
the equipment and receiver.
Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
17.4 This device complies with the part 15 of
the FCC Rules and the Industry Canada license
- exempt RSS standards(s). Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
YOU MUST PREPARE:
One hardboard (not included)
Thickness: 1/4’’ (6 mm)
Minimum dimensions:
13’’ x 13’’ (33 x 33 cm)
Maximum dimensions:
equal to the mattress size
WHAT YOU WILL NEED (NOT INCLUDED):
Miniature Philips
Screwdriver
3 AA Alkaline
Batteries for Nursery
Unit
VIDEO, MOVEMENT
& SOUND MONITOR
Model AC1300
IMPORTANT
The hardboard must be larger than the Sensor Pad
surface area or in the case of the AC1300-2SP of
two Sensor Pads.
SETUP REQUIREMENTS
3X
INCLUDED:
Parent Unit with
R
echargeable Battery
Nursery Unit
6
5
4
32 1
1 Sensor Pad (AC1300) or 2 Sensor Pads
(AC1300-2SP) with pre-installed cord covers
2 AC Adapters
2X
Hardboard
73
F
5
E
N
02mf13_Manuel_AC1300_NA_12301.indd 5 2016-06-29 11:06 AM
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Angelcare AC1300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Angelcare AC1300 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 21,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info