541774
6
Zoom out
Zoom in
Previous page
1/20
Next page
SVT-VR Bass Guitar Amplifier
6
11. TREBLE: Use this to adjust the high
frequency level of channel two. This
provides up to 12 dB of boost, or
12 dB of cut at 4 kHz. The high
frequency output is flat at the center
position.
12. BASS: Use this to adjust the low
frequency level of channel two. This
provides up to 12 dB of boost, or
12 dB of cut at 40 Hz. The low
frequency output is flat at the center
position.
13. ULTRA-HI: This switch, when engaged
[right side down], enhances the amount
of high frequency output of channel two.
The amount of boost is dependent on
the setting of the volume control [10].
14. ULTRA LO: This switch, when engaged
[right side down], enhances the low
frequency output of channel two.
The Front Panel continued
15. STANDBY SWITCH: Use this switch to
turn the standby power on or off. Flick
the switch up to turn the standby on.
The standby mode allows the tubes to
warm up or remain warm without high
voltage being applied to them. This
helps extend tube life. This switch should
be OFF when first turning the amplifier
on. Allow the unit to warm up for at least
20 seconds before switching to the ON
position. During short periods of
non-use, the amp should be put into
standby mode.
16. POWER SWITCH: Use this switch to
turn the overall system power on or
off. Flick the switch up to turn on the
power. The power switch should be
engaged prior to the standby switch
(as mentioned above, #15). This
switch must be turned off to reset
the amp after a Fault condition. The
adjacent lamp illuminates green when
the amplifier is on and is not in
standby mode.
1 2 3 4
7 8 9 13 14
5 6 10 11 12 15 16
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ampeg SVT-VR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ampeg SVT-VR in the language / languages: English as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info