541774
5
Zoom out
Zoom in
Previous page
1/20
Next page
SVT-VR Bass Guitar Amplifier
5
The Front Panel
1. ONE: (The Channel One Input jacks):
The signal output from an instrument
or a line-level signal may be connected
to this 1/4" input by means of a
shielded instrument cable. Either the
bright or normal jack may be used.
The bright jack enhances the high
frequencies of the input signal. The
signal at these jacks is sent into the
channel one preamp section [tone
and volume controls].
2. TWO: (The Channel Two Input jacks):
The signal output from an instrument
or a line-level signal may be connected
to this 1/4" input by means of a
shielded instrument cable. Either the
bright or normal jack may be used.
The bright jack enhances the high
frequencies of the input signal. The
signal at these jacks is sent into the
channel two preamp section [tone
and volume controls].
3. VOLUME: Use this control to adjust the
output level of channel one.
4. TREBLE: Use this to adjust the high
frequency level of channel one. This
provides up to 12 dB of boost, or
12 dB of cut at 4 kHz. The high
frequency output is flat at the center
position.
5. MIDRANGE: Use this to adjust the
midrange frequency level of channel one.
This provides up to 20 dB of boost, or
20 dB of cut at the selected frequency
[8]. The midrange frequency
output is flat at the center position.
Rotate the control counter-clockwise
for a “contoured” sound (more distant,
less midrange output) or clockwise for a
sound which really cuts through.
6. BASS: Use this to adjust the low
frequency level of channel one. This
provides up to 12 dB of boost, or
12 dB of cut at 40 Hz. The low
frequency output is flat at the center
position.
7. ULTRA-HI: This switch, when engaged
[right side down], enhances the amount
of high frequency output of channel one.
The amount of boost is dependent on
the setting of the volume control [3].
8. 1•2•3: This switch selects the
frequency that will be affected by the
midrange control [5]. The available
frequencies are 220 Hz [left side of
the switch engaged], 800 Hz [switch
in the center position], or 3 kHz (right
side of the switch engaged].
9. BASS-CUT/OFF/ULTRA-LO: Engaging
the left side of this switch decreases
the low frequency output of channel
one. Engaging the right side of this
switch enhances the low frequency
output of channel one. The switch is
inactive in the center position.
10. VOLUME: Use this control to adjust the
output level of channel two.
1 2 3 4
7 8 9 13 14
5 6 10 11 12 15 16
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ampeg SVT-VR at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ampeg SVT-VR in the language / languages: English as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info