8 Basic operations
Turn on STB
First, press the [ POWER] to turn on the
unit.
When the STB is first used, there will play the
first channel from the default Channel List. If
the STB is not first used, STB will play the
same channel as last time before turning off.
? Frequently Asked Question
Q: The power of my STB has been turned
on and not in Standby mode, but the
TV screen showed nothing:
A: Make sure the TV set has been set to the
correct video input (not the TV channels).
For example, if you have connected the
unit with the Video1 input of the TV set,
the TV set has to be switched to Video1.
Q: The power of my STB has been turn on
and not in Standby mode, but the TV
screen showed nothing except popup
window with “No Signal” information.
A: That means the channel, which you select,
is no signal. Check connection of signal
cable or contact operator.
Power
1. Press [ POWER] Key can enter the
Standby state
2. In Standby state, press [ POWER] Key
again can call back the unit and go on play
the previous channel
3. User can also disconnect the device’s
main power to end the Standby state.
Channel Up/Channel Down
In full screen, press [↑/↓] to change channel.
Volume Up/Volume Down
In full screen, press [←/→] or [ vol+/vol-] to
adjust volume.
Number
In full screen, use number key and press
[ENTER] on the Remote Control Unit to
change channel.
Mute
1. Press [ MUTE] key to mute the sound
and the screen will show up mute OSD.
2. Press [ MUTE] key again to restore
sound.
Pause
1. In playing mode, press [ PAUSE] key,
the picture will be paused, but the sound of
the channel will still continues.
2. Press [PLAY] key , the screen’s picture
will skip over to the current playing picture,
and the sound of the channel will
corresponding playing.
Recall
Press [ RECALL] key will directly switch to
the previous channel that you played before
current channel.
Favourite
1. In full screen, press [FAV(FAVORITE)]
key, it will display a window of “Favorite
Group” on the left of the screen, which you
can watch like below:
