661060
8
Zoom out
Zoom in
Previous page
1/16
Next page
ALPINE MRV-M1200 68-29530Z91-A (EN/FR/ES)
6-EN
2. Rem
o
leads
NOTES:
If lengt
connec
or soun
On the
electric
3. Tighte
hexag
Befor
shrin
exten
W
NOTES:
Use on
For safe
To prev
droppi
carry th
RCA Input Jacks
Connect these jacks to the line out leads on your
head unit using RCA extension cables (sold
separately). Be sure to observe correct channel
connections; Left to Left and Right to Right.
NOTE:
Use either RCA line level or speaker level
inputs. Do not connect both at the same time.
Pre-Out Jacks
These jacks provide a line level output. This is an
ideal output for driving a second subwoofer
amp. This output is full-range, and is not affected
by the crossover.
Remote Bass Control Jack
Connection Cable
Remote Bass Control Unit
The Remote Bass Control Unit adjusts the output
level remotely. This is not to replace appropriate
gain level setting between the amplifier and
head unit.
Speaker Input Connector
Front Left Speaker (White (+))
Front Left Speaker (White/Black (–))
Front Right Speaker (Gray (+))
Front Right Speaker (Gray/Black (–))
Rear Right Speaker (Violet/Black (–))
Rear Right Speaker (Violet (+))
Rear Left Speaker (Green/Black (–))
Rear Left Speaker (Green (+))
CAUTION
About Power supply wires
If the length of the power and ground cables
exceed 1 m, or if you connect more than one
amplifier, a distribution block should be used. See
below for wire gauge recommendations for
distribution block connection to battery and
ground (depends upon wire length necessary):
2 AWG (33 mm
2
) or 1/0 AWG (53 mm
2
)
MRV-M1200
BATTERY GROUND
4 AWG
(21 mm
2
)
Distribution
block
1 m
(Max.)
2 AWG (33 mm
2
) or
1/0 AWG (53 mm
2
)
To vehicle’s
battery
To vehicle’s
chassis
Connect all equipment to the same ground point while
keeping wire length as short as possible.
Ensure that you install a correctly-rated in-line fuse
on the power cable near the battery positive post.
Cautions on wire lead connections
When using third-party wire cables (power supply
wire), use the supplied screws to simplify the
connection. Refer to the description below for the
proper procedure. If you are in doubt about how to
make this connection, consult your dealer.
1. Check the wire size.
Required Wire Size
– Battery Lead/Ground Lead ....4 AWG (21 mm
2
)
– Remote Turn-On Lead .............12 AWG (3 mm
2
)
– Speaker Output Lead ................8 AWG (8 mm
2
)
If the wire gauge used is unknown, ask your
dealer.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine MRV-M1200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine MRV-M1200 in the language / languages: English as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info