Manual Alpina AT2 72 HA (page 76 of 251) (All languages)

731527

Zoom out

Zoom in

1/251

5. REGULATIONS FOR USE

5.1 BEFORE EACH USE

Before every use, perform the following

checking procedures in order to assure a regular

operation. The fuel characteristics are provided

in the specic paragraph (see 4.2 and 8.1).

5.1.1 

1. Place the machine on a at surface.

2. Clean around the oil ll cap.

3. Unscrew the cap (g. 2.A), clean the end

of the dipstick (g. 2.B) and slide it back

in until the cap is touching the hole, as

shown, without screwing it back on.

4. Remove the cap with the dipstick and

check the oil level that must be between

the «MIN» and «MAX» marks.

5. If oil is required, add oil of the same kind

up to the «MAX» mark, being careful

not to spill any outside the oil ll.

6. Fully tighten the llercap (g. 2.A)

and wipe o any spilled oil.

NOTE Top up gradually, adding small amounts

of oil, checking the level each time.

Do not top up beyond the «MAX» level;

an excessive level can cause:

• smoking from the exhaust;

• soiling of the spark plug or air lter with

subsequent diculty for ignition.

NOTE For the required type of oil, observe the

indications provided in the technical data table.

5.1.2 

The eciency of the air lter is

essential to correct engine operation;

do not start up the engine if there is no

ltering element or it is broken.

1. Clean around the lter cover (g. 3.A).

2. Take the cover o (g. 3.A) by

unscrewing the two knobs (g. 3.B).

3. Check the state of the ltering element

(g. 3.C), which must be intact, clean

and in perfect working order; otherwise

service or replace it (par. 6.5).

4. Put the cover back in place (g. 3.A).

5.1.3 

The refuelling operations are described in the

machine manual and are mentioned here.

To refuel:

1. Unscrew the fuel cap and take it o.

2. Set a funnel on the hole.

3. Refuel and take the funnel o.

4. At the end of refuelling, screw the cap

back on and clean any spillage.

IMPORTANT Avoid getting fuel on the

plastic parts of the engine or machine to avoid

damaging them, and immediately clean o

every trace of spilled fuel. The warranty does not

cover damage to plastic parts caused by fuel.

5.1.4 

Firmly connect the cap (g. 4.A) of the

spark plug cable (g. 4.B), ensuring

that there are no traces of dirt inside the

cap or on the spark plug terminal.

5.2 

The engine must be started up as described

in the machine's Instructions Manual, always

being careful to uncouple any device (if

applicable) that is capable of making the

machine travel forwards or stop the engine.

1. Place the throttle on «CHOKE»

(if applicable) or «FAST».

2. Turn the starter key as described in

the machine's Instructions Manual.

After a few seconds, gradually

move the throttle from «CHOKE» (if

applicable) to «FAST» or «SLOW».

5.3 STARTING THE ENGINE



Follow the entire procedure described for

cold starts, with the throttle on «FAST».

5.4 ENGINE USE DURING OPERATION

To optimise engine output and performance,

it must be used at maximum rpm, by

placing the throttle on «FAST».

IMPORTANT Do not work on slopes

exceeding 20° to avoid jeopardising

correct engine operation.

5.5 STOPPING THE ENGINE

DURING OPERATION

1. Place the throttle on «SLOW».

2. Let the engine run at minimum

for at least 15-20 seconds.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Alpina AT2 72 HA in the language / languages: All languages as an attachment in your email.

The manual is 7,56 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Alpina AT2 72 HA Manual

Product: