541402

Allied Telesis AT-GS950-8 Manual

24
Zoom out
Zoom in
Previous page
1/50
Next page
Chapter 1: Overview
24
Caution
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.
1. This will take up approximately 1 to 2 minutes before the switch comes
back on line and is ready to switch Ethernet traffic again.
Factory default reset - By pressing the button greater
than 10 seconds, you will initiate a software reboot of
the switch and reset all of the configuration parameters
of the switch to the factory default settings - including
the management IP address.
When the switch is reset to factory defaults, its IP address will
revert to 192.168.1.1. If your browser is configured for another IP
address, you will have to reconfigure your browser and workstation
before you can again connect to the switch.
Both the reboot and factory default reset functions can
be disabled in the management software. For more
information, refer to the AT-GS950/8, AT-GS950/16, or
AT-GS950/24 Management Software User’s Guide.
Power Supply
The switch has an internal power supply with a single AC power supply
socket on the back panel and autoswitch AC inputs. To power the switch
on or off, connect or disconnect the power cord provided with the switch. A
power cord is supplied with the switch.
Note
For the power requirements, refer to the “Power Specifications” on
page 48.
Network Topologies
This section illustrates two network topologies of the AT-GS950/16 and
AT-GS950/24 Layer 2 Gigabit Ethernet Switches: Gigabit Ethernet to the
desktop and Gigabit Ethernet backbone.
Gigabit Ethernet
to the Desktop
The topology shown in Figure 3 is commonly referred to as Gigabit
Ethernet to the desktop. This topology provides the best in performance
and reliability because each end node is connected directly to the AT-
GS950/16 Switch with a dedicated network link
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allied Telesis AT-GS950-8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allied Telesis AT-GS950-8 in the language / languages: English as an attachment in your email.

The manual is 1,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info