541404

Allied Telesis AT-8000-8POE Manual

338
Zoom out
Zoom in
Previous page
1/360
Next page
Chapter 32: Getting Started with the Command Line Interface
338 Section III: Using the Command Line Interface
Interface
Configuration
Command Mode
The Interface Configuration command mode allows you to configure
features that pertain to the ports on the system such as flow control, port
mirroring, and duplex mode. To access this mode, you must first access
the User EXEC, Privileged EXEC, and Global Configuration modes. From
the Global Configuration mode, type:
interface ethernet1/port
You can specify a port or a range of ports. Separate a list of ports with
commas or a dash. The prompt changes to Switch(config-if)# to indicate
the Interface Configuration mode.
See the “Port Mirroring Example” on page 339 for a procedure that
describes how to set the port mirroring in the Interface Configuration
mode.
After you have accessed the Interface Configuration mode, the commands
you enter apply to the ports specified in the Global Configuration mode. To
perform port-specific commands on another group of ports, you must first
exit the Interface Configuration mode and then specify the new ports in the
Global Configuration mode before returning to the Interface Configuration
mode.
For a list of commands that can be accessed from the Interface
Configuration command mode, see Table 15.
Table 15. Interface Configuration Command Mode Commands
Commands Description
DEFAULT-
PRIORITY
Sets priority for a port.
DOT1X Sets the 802.1 protocol configuration.
END Exits from the Interface Configuration Command Mode
to the Global Configuration Command Mode.
EXIT Exits from the Interface Configuration Command Mode
to the Global Configuration Command Mode.
FLOW-CTRL Sets the parameters for the flow control feature.
GETPORT Provided information about the ports.
LOGOUT Exits the command line interface and returns to the
Main Menu.
MODE Displays the available modes.
NO Negates a command or sets its defaults.
OVERRIDE Enables the port override feature.
… 338 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allied Telesis AT-8000-8POE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allied Telesis AT-8000-8POE in the language / languages: English as an attachment in your email.

The manual is 5,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info