541398
106
Zoom out
Zoom in
Previous page
1/134
Next page
106 AR400 Series Router User Guide
Software Release 2.7.1
C613-02021-00 REV F
4. Configure IP.
To enable the IP module, and assign IP addresses to the interfaces, enter the
commands:
ENABLE IP
ADD IP INTERFACE=PPP0 IPADDRESS=189.124.7.9
MASK=255.255.0.0
ADD IP INTERFACE=PPP1 IPADDRESS=203.45.90.2
MASK=255.255.255.0
ADD IP INTERFACE=ETH0 IPADDRESS=172.73.1.2
MASK=255.255.255.0
5. Configure IGMP.
To enable IGMP on the router for multicast group management, enter the
command:
ENABLE IP IGMP
To enable IGMP on the interfaces that have potential multicast receivers (IP
hosts) connected to them, and the interfaces using DVMRP, enter the
commands:
ENABLE IP IGMP INTERFACE=ETH0
ENABLE IP IGMP INTERFACE=PPP0
ENABLE IP IGMP INTERFACE=PPP1
6. Configure DVMRP.
To enable DVMRP for multicast routing, enter the command:
ENABLE DVMRP
Enable DVMRP on the interfaces that use DVMRP for multicast routing.
Setting the metrics on each of the interfaces influences the path cost and
therefore the traffic sent over the interface. (The higher the metric, the
higher the path cost, and the lower the traffic over the interface.) Enter the
commands:
ADD DVMRP INTERFACE=ETH0 METRIC=1
ADD DVMRP INTERFACE=PPP0 METRIC=6
ADD DVMRP INTERFACE=PPP1 METRIC=3
Configure multicast routing using DVMRP on Router B.
1. Set the system name.
To set a unique system name for the router, enter the command:
SET SYS NAME=B-dvmrp
2. Configure PPP.
To create a PPP interface over a synchronous port, enter the command:
CREATE PPP=0 OVER=SYN0
106


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Allied Telesis AR410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Allied Telesis AR410 in the language / languages: English as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info