794955

Alecto WS5400 Manual

27
Zoom out
Zoom in
Previous page
1/90
Next page
27
WIRELESS 7-IN-1 SENSOR ARRAY
22. Antenna
23. Rain collector
24. UVI / light sensor
25. Mounting pole
26. Mounting base
27. Balance indicator
28. Wind cup
29. Radiation shield
30. Wind vane
31. Red LED indicator
32. RESET key
33. Battery door
34. Mounting clamp
35. Rain sensor
36. Tipping bucket
37. Drain holes
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
3. INSTALLATION OF THE WS5400
PRE CHECK
Before permanently install your weather station, we recommend the user to operate the weather station at a location which
is easy to access to. This will allow you to get familiar with the weather station functions and calibration procedures, to
ensure proper operation before installing it permanently.
SITE SELECTION
Before installing the sensor array, please consider the followings:
1. Rain-gauge must be cleaned every 3 months.
2. Batteries must be changed about every year. We reccomend using Lithium batteries for best performance.
3. Avoid radiant heat reflected from any adjacent buildings and structures. Ideally, the sensor array should be installed at
1.5m (5’) from any building, structure, ground or roof top.
4. Choose an area of open space in direct sunlight without any obstruction of rain, wind, and sunlight.
5. Transmission range between sensor array and display console could reach a distance of 100m at line of sight, providing
there are no interfering obstacles in between or nearby. Check the reception signal quality to ensure good reception.
BATTERY INSTALLATION OUTDOOR UNIT
Unscrew the battery door at bottom of unit and insert the batteries
according to the +/- polarity indicated. Screw the battery door
compartment on tightly after placing the batteries.
Note:
The red LED (10) will begin flashing every 12 seconds.
Whenever you changed the batteries of the wireless sensor, re-
synchronization must be done manually.
AA
AA
AA
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto WS5400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto WS5400 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5.94 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info