627484
6
Zoom out
Zoom in
Previous page
1/16
Next page
6
Indoor unit:
Slide down the battery cover at the rear of the unit and insert 3 AA 1.5V batteries according to the markings
inside the battery compartment. Slide the battery cover back onto the indoor unit. (Batteries are not included)
The indoor unit will now start a 1 minute scan to search for the outdoor unit. Therefore, you’ll need to
insert the batteries into the outdoor unit within that minute.
Outdoor unit:
Open the battery compartment by loosening the battery cover using a small
crosshead screwdriver. Install 3 AA 1.5V batteries according to the picture
below, paying attention to the correct polarity (+ and -). Replace the cover and
fasten the screw (batteries are not included).
3.2 Pairing the indoor unit/outdoor unit:
Automatically:
As soon as you insert the batteries into the indoor unit, the indoor unit will start a 1 minute scan to
search for the signal of the outdoor unit. Therefore, if you insert the batteries into the outdoor unit within
that minute and the units will ‘find’ each other, they will be automatically paired and the display of the
indoor unit will show the temperature transmitted by the outdoor unit.
Manually:
If the units cannot be paired automatically, or after replacing the batteries, you can pair the outdoor unit
(again) with the indoor unit as follows:
1. press and hold the SCAN button on the indoor unit for 2 seconds until the antenna symbol starts
flashing in the display
2. Press briefly press the RESET button on the outdoor unit
3. the units will have found each other (again) after several seconds
3.3 Positioning: reset
Indoor unit:
You may suspend the indoor unit from a simple screw in a wall or use it as a desk model
with the supplied support. In any case, never place the indoor unit in direct sunlight or next
to heat radiating lights or stoves.
Outdoor unit:
You may place the outdoor unit on a flat surface (such as a fence or railing)
or on top of a pole (not included). In any case, make sure the unit is placed
at least 1.5 meters above the ground and ensure the unit is standing freely
in the rain and wind.
Outdoor unit positioning tips:
To ensure that the rain meter is functioning as accurate
as possible, the outdoor unit must be standing exactly
horizontal. You can verify this by using the built-in spirit
level at the top of the outdoor unit.
To be able to check from which direction to wind is
coming, the outdoor unit should be aimed to the North. To do this, use the N
marking on top of the outdoor unit. Use an accurate compass (not included)
to properly orient the unit.
Make sure that the distance between the outdoor unit and indoor unit is no
greater than 50 to 100 meters.
reset
>1,5m
N
-
-
+
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto WS-4800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto WS-4800 in the language / languages: English as an attachment in your email.

The manual is 3,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alecto WS-4800

Alecto WS-4800 User Manual - German - 16 pages

Alecto WS-4800 User Manual - Dutch - 16 pages

Alecto WS-4800 User Manual - French - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info