97519
21
Zoom out
Zoom in
Previous page
1/29
Next page
21
AUTO POWER OFF (TM-56 only)
After not being used for about 30 minutes, the tester goes into sleep-mode. Press the
ON/OFF button twice to power up again.
CHANGE BATTERY / FUSE
Before attempting to replace the battery or fuse, disconnect the test leads from any
energized circuit to avoid shock hazard and switch-OFF the tester.
1. Remove the measuring leads from the instrument.
2. Remove the two screws in the bottom of the case and remove the plastic cover.
3. A. Battery :replace the battery for a fresh 9V battery, preferably alkaline.
3. B. Fuse :remove the PCB (no screws) and replace the fuse (TM-36: 2A/250V
and 10A/250V, TM-56: 0,3A/250V).
4. Replace the plastic cover and close the tester.
Never throw away empty batteries but hand them over to your local depot
for chemical waste.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alecto TM 36 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alecto TM 36 in the language / languages: Dutch, French as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info