Manual Alde Compact 3020 HE - rev 1442 (page 10 of 18) (English)

626267

Zoom out

Zoom in

1/18

20. *Floor heating

This function makes it possible to control

the operation of the oor heating pump in

a water-borne oor heating system. Floor

heating pump operation starts at the same

time as the heating system's circulation

pump starts. The oor heating control has a

current-saving function that means the oor

heating pump is in operation for 5 min and

then stationary for 5 min in intervals as long

as heating is required.

Mode: Press the arrows so that Delay or

cont. is activated. The oor heating is on in

these two modes. The oor heating is turned

off in Off mode.

Delay: The oor heating pump runs for a cer-

tain time after the circulation pump has stop-

ped. This Delay can be set to 15 min, 30 min

or 120 min. NB! It may get hotter than requi-

red in the vehicle In cont. mode as heat

regulation has been rendered useless!

To exit the tools menu, press Return or Menu.

15. *Booster

This function enables setting two different

speeds for one booster. Fan start and stop

is controlled from the boiler. If the boiler’s

circulation pump starts up, the fan on the

booster will as well. When the circulation pump

stops, the fan will continue to run for another

six minutes and also stop unless the circulation

pump has started again, i.e. giving automatic

control of the booster fan.

16. *Setting room sensor

With this function you can choose the tempera-

ture to be active. You can set whether the sensor

located in the accommodation part, the sleep-

ing part or in the panel is to be active. If Auto is

selected, the sensor in the panel is active and

will automatically switch to room sensor (sofa

and/or bed) if one is connected. If two room

sensors are connected, it will be the one for the

accommodation part that is active (sofa).

17. *Load monitor

This function is used to prevent the fuses for

a 230 V power supply being overloaded. If the

total current consumption of the vehicle exceeds

the set value, the electrical output of the boiler

will be reduced automatically. This also applies

to Truma Comfort AC if connected to the panel.

Due to voltage variations and tolerances, you

can choose different levels of regulation (5-17 A).

If the fuse blows, choose a lower setting.

NB! AC must be turned on from the panel

and not via the AC remote control if it is to

work with the load monitor.

18. *EisEX, 12 V defroster for gas regulator

This is a little heating element that prevents

ice forming in the regulator in winter (for Mono

Control CS, DuoControl CS, DuoControl and

DuoComfort). If DuoControl CS or DuoControl

is installed and connected, symbols will be dis-

played together with the gas bottle symbol in

the rest menu to show what has been selected.

Snowake = EisEX ON

Sun = EisEX OFF

19. *Engine heater

This function makes it possible to use the

heating system to heat the engine in

a motor caravan, bus, etc.

Engine heater start: Press the button marked

Off, the text will change to On and the button

will turn green. Then set the required starting

time and day. Engine heating starts at the set

time and day, heating is then active for 60 minu-

tes and will stop automatically. NB! Note that

the clock in the panel must be set if the fun-

ction is to work as desired.

Functions marked with a (*) are accessories, which are not installed on all vehicles, refer to the vehicle

manufacturer's instructions.

My heating at night seems to switch on and of within half a minute or so. Should it be that regular.
Regards D. Davis Submitted on 4-5-2022 at 21:03
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Alde Compact 3020 HE - rev 1442 in the language / languages: English as an attachment in your email.

The manual is 4,21 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alde Compact 3020 HE - rev 1442

Alde Compact 3020 HE - rev 1442 User Manual - German - 18 pages

Alde Compact 3020 HE - rev 1442 User Manual - Dutch - 18 pages

Alde Compact 3020 HE - rev 1442 User Manual - French - 18 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Alde Compact 3020 HE - rev 1442 Manual

Product: