Manual Al-ko Motorhacke AL-KO MH 4001R (page 13 of 88) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish)

601545

Zoom out

Zoom in

1/88

GB 3 Translation of original user instructions

Engine Start

At engine start, clutch lever of weeder share

can’t be activated!

 Set-up saturator lever into position "START"

 Pull out quickly starter cable and afterwards,

let it slowly wind up!

Putting of Weeder Share into Operation

 Pull up clutch lever entirely and hold it.

Weeder share will begin to rotate only at the

second half of lever motion.

Breaking of Weeder Share

 Loose clutch lever.

If you will loose clutch lever, weeder share

can’t rotate!

Starting reverse drive

Never start the reverse drive while moving

forward. Danger of severe damages to the

machine!

 Pull up lever for reverse drive as far as it will

go.

Disconnection of reverse drive

 Release lever for reverse drive.

Engine Breaking

 Set-up saturator lever into position "STOP".

Maintenance

Before all Maintenance and Cleaning

Works Disconnect the Connector from

Spark Plug!

 Clean the machine after its utilization.

 Do not spray the machine with water. Water

in ignition device or in carburetor can pro-

voke troubles.

If the machine is inclined to its side, the

carburetor must be pointed upwards.

Professional Control is necessary:

 at abrupt engine stop

 at weeder share distortion

 at gearbox damage

 at V-belt pulley damage.

Refilling of Gear Oil

As a matter of principle, the gear oil should be

changed after 100 operating hours. (oil viscosity

SAE 80).

Oil change

Required oil amount:

 Type series 4000, 5000 approx. 0.5 l.

 Type MH 350-4 approx. 0.2 l.

 Loosen oil screw plug (Fig. 15).

 Fill new oil.

 The oil must be visible at the filling opening.

 Close feed opening by screwed drain plug.

Engine

Oil Refilling / Air Filter / Spark Plug

See – Operating instructions delivered by engine

producer.

Setting-up of Bowden cables

Fine setting-up is being made by means of an

adjusting screw on upper handle (Fig. 6 and 12)

and on engine support (on ends of Bowden

cables).

 Loose the safety nut.

 Set up by means of adjusting screw.

Correct Setting-up:

Weeder shares can begin to rotate only in the

second half of lever motion.

 Tighten the safety nut.

Gas Uptake

See – Operating instructions delivered by engine

producer.

Maintenance and storage

Before you start any work on the unit:

Switch the engine off, wait until the weeding

shares Stop; unplug the connector of the spark-

ing plug.

Wear protective gloves when manipulating the

weeding shares.

Never store the unit with fuel in the tank in build-

ings where fumes may reach an open flame or

spark

– risk of explosion!

The fuel tank is to be drained outdoors only.

Allow the engine to cool before storing it in the

locked up area.

Never squirt the unit with water.

All repairs shall be carried out by authorized

service dealers only.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko Motorhacke AL-KO MH 4001R in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 4,39 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Al-ko Motorhacke AL-KO MH 4001R Manual

Product: