Manual Al-ko MH 5065 R (page 13 of 60) (English, German, Dutch, French, Italian, Swedish, Norwegian)

601550

Zoom out

Zoom in

1/60

Safety instructions

441542_a 13

The machine must not be operated if the ope-

rator is under the influence of alcohol, drugs

or medication.

Observe local ordinances regarding opera-

ting times.

Work only when there is adequate daylight or

artificial lighting.

CAUTION!

Always perform a visual check prior to

start-up.

Use the machine only in perfect working or-

der.

Note that the user is responsible for accidents

and damage caused to other persons and/or

their property

Do not deactivate safety and protection de-

vices

Do not place your hands and feet close to any

rotating parts.

Never lift or carry the mower while the motor

is running

Always ensure stability when working.

The user is responsible for accidents invol-

ving other people and their property.

Do not leave the appliance unsupervised.

Keep exhaust and engine clean.

Store petrol in designated containers only.

Only refuel in open air.

Replace a damaged petrol tank and/or tank

cap.

Only replace damaged or worn parts by ge-

nuine spare parts.

Subject to changes in design and configura-

tion.

While starting the engine be sure that is

nobody standing in front of the unit or its

working devices (weeding shares) – drive of

the weeding shares must be off.

Transport wheel is to be either installed or re-

moved and the breaking clutch is to be adjus-

ted only when the engine is off and the weed-

ing shares are not running.

When transporting it with the installed trans-

port wheel switch the engine off and wait until

the weeding shares stop.

The unit is allowed to be used only under

safety distances specified by the handgrip.

Always work transversely to the slope.

Never work up and down the slope with the

inclination angle bigger than 10°.

Never open the cap of the fuel tank, or add

fuel, while the engine is running or the unit is

hot.

Use a funnel or a filler pipe when refuelling so

that no fuel is spilled on the engine, the deck

or the ground.

Do not start the engine if petrol has over-

flowed. The appliance may be cleaned, and

any attempt at ignition may be made, only

when the petrol vapours have dissipated.

For safety reasons, never use the engine with

worn or damaged parts. Such parts must al-

ways be replaced, not repaired. Use OEM

spare parts. Spare parts of inferior quality can

damage the engine and endanger your safety

Renew exhaust silencers if damaged.

Do not change the engine governor settings.

STARTUP

Put the machine into operation only after its com-

plete assembly.

CAUTION!

Tank Oil and Petrol before the First Put-

ting into Operation! It´s necessary to re-

spect unconditionally instructions in en-

closed operating instructions for petrol

engine delivered by engine producer.

Setting-up of Handle Height

Set-up handle height according to your proper

body size.

Common setting-up of height corresponds to

haunch height.

Loose screws on cover support.

Set-up handle height according to long holes.

Tighten screws.

Transport Wheel

Motor cutter can be transported to given place by

means of transport wheel.

If you will operate the motor cutter, remove the

transport wheel or fix it into upper grip .

Engine Start

At engine start, clutch lever of weeder share can’t

be activated!

Set-up saturator lever into position "START"

Pull out quickly starter cable and afterwards,

let it slowly wind up!

Does the alco mh5065r have a separate oil tank from the engine . Submitted on 15-3-2022 at 16:09
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko MH 5065 R in the language / languages: English, German, Dutch, French, Italian, Swedish, Norwegian as an attachment in your email.

The manual is 5,46 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Al-ko MH 5065 R Manual

Product: