161790
5
Zoom out
Zoom in
Previous page
1/11
Next page
4
dx turntables
english
19.Headshell - Install cartridge here. When installing a cartridge, refer to the
installation instructions supplied by the manufacturer of that cartridge. During
installation, attach the stylus protector to guard the stylus tip from damage.
Attach wires as follows:
White (L+) Left channel+
Blue (L-) Left channel -
Red (R+) Right channel+
Green (R-) Right channel-
TONE ARM ASSEMBLY
1. Push the power to on and the speed indicator and the strobe- 10. Set the desired pitch adjusts range by depressing the buttons until
illuminator will light up. the desired pitch is reached.
Options are +/-8% or +/-12% or +/-20%.
2. Insert target light for illumination the stylus.
11. Adjust the pitch to a desirable speed. During play, observe the
3. Place a record on the turntable mat. When playing a 45rpm
strobe dots. If the strobe dots appear to the right, the pitch is
record with a large center hole; place the 45-rpm adapter on the
slower than the rated speed. If they flow to the left, the rated
centre spindle.
speed.
If the strobe dots appear stationary, which means the platter is in
4. Set the rotation speed (33/45/78) to match the record.
normal turntable speed, move the pitch control slider up or down
to adjust the speed.
5. Release the arm clamp.
12. To suspend play, lift tone arm with cueing lever.
6. Set the cueing lever to the up position.
13. When play is finished, raise the cueing lever, move the tone arm to
7. Press the Start/Stop button and the turntable platter will start to the armrest and secure the tone arm with the arm clamp.
rotate.
14. Press the Start/Stop button to stop the platter rotating.
8. Move the tone arm over the desired groove.
15. Push the power to off.
9. Set the cueing lever to the down position, the tone arm will descend
slowly onto the record and play begins.
OPERATION
22
21
20
24
23
19
20.S-Shaped Tone Arm
21.Tone Arm Lift - This elevates the tone arm above the record surface.
22.Anti-Skate Control - This applies inward force to the tone arm so it doesn't skip
outward across the record due to the centrifugal force of the record spinning.
Cartridge manufacturers usually specify the proper setting of this.
23.Counterweight - Adjustment creates the proper downward pressure of the
stylus to the record. Attach now by sliding the counterweight onto the rear of the
tone arm. Twist it lightly and it will screw onto the rear shaft of the tone arm.
24.Tone Arm Clamp and Rest - Use this rest for the tone arm and clamp it in
position during transportation.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Akiyama dx 303 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Akiyama dx 303 in the language / languages: English, Spanish as an attachment in your email.

The manual is 1,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info