630573
168
Zoom out
Zoom in
Previous page
1/170
Next page
156
Appendix
IDE/SCSI Conversion Kit
With the IDE/SCSI Conversion Kit, the IDE hard disk drive can be connected to the internal 50-pin SCSI
connector of the DPS12.
Consult your AKAI professional dealer where you purchased or the AKAI professional Service Center
for the installation of disk drive.
The self-installation may cause serious damages to both the disk drive and DPS12.
Notes:
Use ERASE, instead of FORMAT, to format the IDE drive. The IDE drive may freeze when FORMAT is
performed.
When ERASE is performed on the IDE disk that has been used on other device or brand new disk, an
error message may appear. In this case, perform ERASE again.
Consult your AKAI professional dealer or AKAI professional Service for the drives that can be installed.
Installation - To Service Technicians
IDE/SCSI Conversion Kit Installation
Install the IDE/SCSI Conversion Kit included to the IDE drive by the following procedure. The rest will be the
same as that of SCSI drive.
Note: Set the IDE drive in Master Mode referring to the drive’s manual.
Contents:
ID2SC PC board .................................................................. 1
PCB Mounting Bracket (L), (R) ............................................ 1
40P IDE flat cable ................................................................ 1
4P power cable .................................................................... 1
Plastic rivet........................................................................... 4
Drive Mounting screw (inch-thread 3.2 x 5) ......................... 8
Drive Mounting Plate screw (3 x 10) .................................... 4
Washer (2mm) ..................................................................... 4
ID2SC PCB Installation
1. Attach the PCB Mounting Bracket (L) and (R) to the IDE drive as illustrated. Refer to the direction of ID
hole to the connectors on the IDE drive. Use four inch-thread screws to fix them.
2. Connect the 40P IDE flat cable and 4P power cable to the ID2SC PC board. Place the cables between the
IDE drive and ID2SC PC board and fix the PC board to the PCB Mounting Brackets with plastic rivets.
Care must be taken to avoid pinching the wires by the PC board.
3. Connect the other end of cables to the IDE drive.
4. Set the DIP switch to the default setting as shown.
168


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Akai DPS12i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Akai DPS12i in the language / languages: English as an attachment in your email.

The manual is 2,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info