371062
8
Zoom out
Zoom in
Previous page
1/42
Next page
8
ENGLISH
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an optional outdoor antenna is
recommended.
Connect the outdoor antenna to FM 75 (COAXIAL) jack.
MOUNTING THE FRONT AND SURROUND
SPEAKERS
You can mount the front and/or the surround speakers,if you want
to do so.
Using wall mounting screws (not supplied)
Select a spot that will hold the weight of the speakers and carefully
mount the surround speakers so that they are firmly secured.
Using a speaker mounting kit (not supplied)
The front and surround speakers are equipped with a 5 mm
threaded insert on their back side. Use it to attach the ball shaft
of a speaker mounting kit on the market.
Refer to the instructions of the mounting kit for further information.
You can attach the speakers to the pedestal on the market with
the 5 supplies screws. Refer to the instructions of the pedestal
for further information.
AIWA disclaims any responsibility for injury to persons or
other accidents caused by not fitting the front and/or surround
speakers properly or if the place of the installation is not
suitable.
OPTICAL IN VIDEO 1/OPTICAL IN VIDEO 2
jack / OPTICAL OUT jack
The OPTICAL IN VIDEO 1 jack and OPTICAL IN VIDEO 2 jack
accept digital audio input from connected equipment.
The OPTICAL OUT jack outputs digital audio signals to the
connected equipment.
Connect digital audio playback/recording equipment, such as an
MD recorder , a DAT deck, or a CD-R deck, etc. with optional
optical fiber cables.
Connect the optical input jack of the connected equipment to the
OPTICAL OUT jack, and the optical output jack of the equipment
to the OPTICAL IN VIDEO 1 jack or the OPTICAL IN VIDEO 2
jack.
Before connecting the cable, remove the dust cap from the jacks.
Reattach them when the jacks are not to be used.
CAUTION ON CONNECTING EQUIPMENT TO THE
OPTICAL OUT JACK
When connecting digital equipment without a built-in Dolby
Digital or DTS decoder , do not play back Dolby Digital or
DTS source with multichannel surround sound. When
connecting equipment that does not comform to 96 kHz
Linear PCM source, do not play back 96 kHz Linear PCM
source. It may cause a high level of noise which could harm
your ears and damage the speakers.
The OPTICAL IN VIDEO 1 or 2 jack shares the same video
source as the VIDEO 1 or 2 jack.
SUBWOOFER jack
This jack outputs the low frequency sounds.
Your DVD system comes supplied with a passive (non-powered)
subwoofer , to be connected to the SUBWOOFER
terminals , as
described on page 6.
However , if you wish to connect an optional active (powered)
subwoofer , connect it to this
jack using an optional audio
connecting cord with RCA plugs.
PHONES jack
Connect headphones with a stereo mini plug (ø 3.5 mm,
5
/32 in.).
The jack is located at the front of this unit.
No sound is output from the speakers while the headphones
are plugged in.
When the headphones are plugged in, the Dolby Pro Logic
surround system is canceled. The Dolby Digital or the DTS
surround system automatically switches to the 2ch STEREO
mode.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aiwa ht dv 90 mp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aiwa ht dv 90 mp in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info