28962

Airtronics RD6000super Manual

22
Zoom out
Zoom in
Previous page
1/75
Next page
22
0
25
50
75
100
02550
75
100
0
25
50
75
100
02550
75
100
S
e
r
v
o
T
r
a
v
e
l
S
e
r
v
o
T
r
a
v
e
l
Stick Deflection Stick Deflection
LINEAR THROW
EXPONENTIAL THROW
EXP (EXPONENTIAL)
The RD6000 Super allows the pilot to choose two settings for Exponential throw for each of the primary flight
channels, Elevator, Aileron (and Rudder in helicopter mode).
Exponential throw is primarily used to “soften” or decrease the control stick sensitivity of a control around the neutral
point. With Exponential disabled, a control funtion servo will move in an amount proportional to the amount of control
stick deflection, i.e., 50% stick deflection will result in 50% servo travel; 75% stick deflection will cause the servo to
travel 75% of it presently set maximun throw.
Exponential settings DO NOT change the amount of travel available at 100% stick deflection, but rather it changes
the amount of the servo travel that will occur with stick deflections less than 100%. The first 25% of stick deflection
may be set to result in only 10% of total servo throw making the control less sensitive around neutral. See the
following illustrations.
If you have used Exponential functions before, you will want to start with a small amount of Exponential (10 to 20%)
to determine wheather you like this sort of control response. Exponential is most useful where strong control response
is desired at extreme stick positions but softer response to small stick movement is desired in order to make very
accurate small corrections to flight path.
The switch positions for Exponential #1 and Exponential #2 correspond to the Dual Rate switch positions of Elevator
and Aileron. Exponential #1 is with the Dual Rate switch in the down i.e., Off position. Exponential #2 is with the Dual
Rate switch UP i.e.,ON position. (Note however that you can leave the Dual Rate adjustments for Elevator and Aileron
set at 100% which is no rate, so that switching a Dual Rate switch ON will activate Exponential only.
NOTE: Setting the Exponential with a positive number will make servo movement soft in the neutral area of the stick
movement. Setting the Exponential with a negative number will make servo movement faster in the neutral area and
softer at the end of the stick travel.
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Airtronics RD6000super at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Airtronics RD6000super in the language / languages: English as an attachment in your email.

The manual is 6,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info