521963
25
Zoom out
Zoom in
Previous page
1/47
Next page
offered by Busse-Yachtshop.com
AIR 403 Land Manual Document #0049 REV D
SOUTHWEST WINDPOWER 8/20/2001 25
The voltage regulator is factory set at 14.1 (28.2) volts. The factory setting is marked on the
casting with a small indentation aligned with the screw slot.
To change the setting on the voltage regulator, rotate the adjusting screw 1/8 of a turn for
each 0.7 (1.4) volts change desired. For example, if you want to set your voltage regulator to
14.8 (29.6) volts, turn the adjusting screw clockwise by 1/8 turn, from the 14.1 (28.2) volt
setting.
The adjustment screw will provide regulation settings for voltage ranges at least as wide as
those listed below. The actual voltage set point at the extreme counter-clockwise position
may be as much as 10% lower than the value listed, and at the extreme clockwise position
may be up to 10% higher than the value listed.
AIR Adjustable Voltage Range
12v 13.8v to 17.8v preset to 14.1v
24v 27.6v to 35.6v preset to 28.2v
36v 41.4v to 53.4v preset to 42.3v
48v 55.2v to 71.2v preset to 56.4v
READ THIS BEFORE YOU CONSIDER ADJUSTING THE REGULATION SETPOINT
Turning “up” the regulation set point adjustment will NOT
increase the AIR 403’s output
voltage or amperage. It simply adjusts the “shut down” point for the generators’ voltage
regulator. When the battery voltage reaches the regulation set point voltage, the turbine will
slow down and stop charging the batteries. Turning the screw completely clockwise will NOT
increase the voltage or power output and will only increase the probability of overcharging
your batteries.
5. TROUBLE SHOOTING
If the turbine does not work properly after following the installation instructions, then read this
chapter and carefully compare your installation with each section.
5.1 Assembly
Make sure the blade assembly is on tight. You can check by placing the 5/16” hex key in the
shaft, holding it and attempting to turn the blade assembly. If you can turn the blade,
retighten the blade assembly.
To minimize noise, make sure that you have loosened the four mounting screws and moved
the turbine up 1/8” inch (2mm) and then re-tighten the screws. This will prevent the top of the
pole from touching the hard plastic in the yaw shaft assembly.
5.2 Electrical System
Your battery bank should be a minimum 400 amp hours for 12v systems, and 200 amp
hours for 24v system. If your battery bank is smaller than the recommended size, battery
voltage could quickly rise while the turbine is charging and cause the internal regulator to
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Air Marine Air 403 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Air Marine Air 403 in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info