464372

AEG WSP 300 H Manual

26
Zoom out
Zoom in
Previous page
1/76
Next page
26
For the Fitter
2. Installation instructions
2.1 Technical Data
Model WSP 300 H
Storage Capacity 24 kWh
Rating 3.0 kW
Voltage 3/N/PE ~ 400 V, 1/N/PE ~ 230 V
Dimensions Height: 820 mm
1)
/ 850 mm
2)
Width: 445 mm / 450 mm
2)
Depth: 570 mm / 600 mm
2)
Weight ca 184 kg
Day-acting element 0.5 kW
Core-brick packs 8 x SP28
1)
adjustable from 815 – 840 mm
2)
with working top
2.2 Heater Positioning and Installation
●
The electrical installation of this heater must be approved by your local electricity company.
●
The installation must be carried out by a competent electrician.
●
Electrical installation and local safety regulations must also be adhered to.
●
If heaters are to be installed in commercial or public buildings such as hotels, holiday homes or
apartments, schools, administrative buildings etc., a special warning label is to be attached to the
top of the heater. This label is available from your local contractor.
2.2.1 Procedures to be followed
All National and Local Safety Codes should be adhered to both at the planning and installation
stages.
2.2.2 Choosing the Heater Position
The Kitchen Heater can either be integrated into any fitted kitchen unit or, using the special
accessory set, be installed as a free-standing unit.
The floor must be able to take the weight of the heater. Please, therefore, note carefully the
weight given in the Technical Data section (see section 2.1) of this instruction. If in doubt, consult
a building engineer or architect.
AEG storage heaters generally need no protective underboard when standing on normal flooring,
as long as this is flat and smooth and can withstand temperatures of 80°C minimum.
In the case of soft, load-sensitive or non-heat-resistant floors or carpeting, as well as to even out
any surfaces, it is advisable to first put down a protective board the size of the underside of the
heater. When using high- or thick-pile carpeting a protective board or floor-standing consoles
should definitely be used.
2.2.3 Regulations governing heater position
Due to the low surface temperatures of the side panels, the storage heater can be positioned
directly beside any other integrated appliance in a fitted kitchen.
It is not advisable, however, to place the heater next to a refrigerator or deep-freeze due to
energy-saving considerations. The heater can be placed flush to the rear wall.
The warm air outlet and the cold air inlet must be keep free at all times. Any objects must be
placed at least 30cm from the air grilles.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG WSP 300 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG WSP 300 H in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info