464368

AEG RTi 101 EP Manual

12
Zoom out
Zoom in
Previous page
1/28
Next page
12
For the Fitter
• Swing forward the angle plate in the switching area to take up the mains terminals after
loosening (not completely unscrewing) the screw in the rear wall.
• Insert the cable holders provided in the prepared holes in the angle plate (fig. 6) and fix the wires
in the cable holders as shown in figure 5.
The enclosed cable twisters are used for additional fixing of the cable from the potentiometer (5)
and the 6-wire supply cable to the board as shown in figure 6.
• Feed the 6-pole connector of the discharge control unit (A3 see circuit diagram) up along the
back of the angle plate into the slots „TA“ to „N“ of the terminal block X2 from above and screw
(press cable harness into the existing cable straps).
The cables may not touch the intermediate wall and the heating element connections.
• Attach the preassembled unit consisting of controller and support plate (6) to the upper sheet-
metal bracket of the control panel (support plate of terminal strips X1 and X2). To do so, engage
the lower sheet-metal bracket behind the locking tab of the upper sheet-metal bracket (7). The
two brackets are joined together by means of a screw (M4x8) (Fig. 4).
Designation
double wire (black)
wire with distributor (black)
of
S1
S1
according to
A3 LH and X2 LH
S2
Laying only in connection with ZH
3
1
2
3
4
4
5
1
2
3
56
4
6
7
M4 x 8
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG RTi 101 EP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG RTi 101 EP in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info