648443
13
Zoom out
Zoom in
Previous page
1/36
Next page
13
Operation - Installation
WARNING Burns
Parts of the appliance can get very hot and may
cause burns. Particular caution is advised when
children or vulnerable persons are present.
WARNING Burns
Never cover the appliance.
Never place any objects on top of the appliance.
Do not lean any objects against the appliance.
Do not place any objects between the appliance
and the wall (e.g. to dry clothes).
Do not place any ammable, combustible or
insulating objects or materials, such as laundry,
blankets, magazines, containers with oor po-
lish or naphtha, spray cans or similar, in close
proximity to the appliance.
CAUTION Burns
A minimum clearance of 100 mm must be observed
on all sides (500 mm at the front) between the ap-
pliance and all types of objects, such as furniture,
curtains, textiles or other ammable or non-am-
mable materials.
2.2 Test symbols
See type plate on the appliance.
3. Troubleshooting
If the natural stone heater does not heat up, check in
the fuse box to see if the associated fuses or RCD have
tripped. Remove the cause.
If you cannot remedy the fault, notify your qualied con-
tractor. To facilitate and speed up your request, provide
the number from the type plate (000000-0000-000000).
4. Appliance description
The natural stone heater is an electrically heated marble
or soapstone panel, which is regulated by means of a wall
mounted room temperature controller.
A heating conductor is embedded in the rear of a 30 mm
thick natural stone panel for this purpose, which heats
the panel evenly.
Heat stored in the natural stone panel is released in the
form of long wave radiation (comparable with solar rays).
Consequently, occupants and objects alike are heated in
the room without any air turbulence.
Thanks to the use of special rawl plugs for attaching the
wall mounting brackets to the natural stone panel, the
mounting points are invisible from the front. This means
that the structure of the panel is uninterrupted. The wall
mounting brackets are convertible, so the natural stone
heater can be mounted horizontally or vertically.
Towel holder
The towel holder available as a special accessory is used
for heating or drying textiles dampened by water (no che-
mical cleaning agents).
5. Operation
The natural stone heater is controlled exclusively via a
wall mounted room temperature controller (on nished
or unnished walls).
Observe the operating and installation instructions for the
relevant controller.
6. Maintenance and care
Clean the natural stone heater with a damp cloth when it
has cooled down. Do not use any abrasive or corrosive
cleaning products.
INSTALLATION
7. Safety
Only a qualied contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
Fit the appliance to a vertical wall that is tempera-
ture-resistant to at least 90 °C.
Maintain the minimum clearances to adjacent object
surfaces.
Observe the type plate
The specied voltage must match the mains voltage.
Only use a permanent connection to the power
supply.
Never install the appliance directly below a wall
socket.
Ensure the appliance can be separated from the
power supply by an isolator that disconnects all
poles with at least 3 mm contact separation. Do not
install the appliance with a xed power cable.
When installing the heating appliance in rooms with
a bath and/or shower, observe the safety zone ac-
cording to VDE 0100, part 701, in accordance with
the details on the appliance type plate.
The mains junction box must not be installed in safe-
ty zone 1 or 2 in this instance.
Install the appliance in such a way that switching and
control equipment cannot be touched by a person in
the bath or shower.
Design all materials in accordance with the rated
consumption of the appliances.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG NSH 165 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG NSH 165 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info