565732
16
Zoom out
Zoom in
Previous page
1/48
Next page
- 15 -
EINFÄDELN MIT DER ZWILLINGSNADEL / TWIN NEEDLE THREADING
7
6
1. Nehmen Sie den 2. Garnrollenhalter aus dem Zubehörfach und
stecken Sie ihn in die dafür vorgesehene Halterung.
2. Stecken Sie die Garnrollen auf die beiden Garnrollenstifte. (Achten Sie
darauf, dass die Enden auf der rechten Seite sind.)
3. Fädeln Sie die beiden Fäden genauso wie bei einem einzelnen Faden
ein.
4. Nach dem Durchfädeln durch die Führungen siehe 5 müssen die
Fäden dann durch die einzelnen Nadelöhre 6 gefädelt werden.
Hinweis:
1. Das automatische Einfädelsystem kann bei zwei Nadeln nicht
verwendet werden.
2.
Die Stichbreite darf zwei Drittel der maximalen Breite nicht
überschreiten, da sonst die Nadel brechen kann.
Zwillingsnadeln und Garnstift sind optional zu erwerben.
1. Take out the extra spool pin from the accessories and place into the slot
of spool pin arm .
2. Place spools of thread on both spool pins and spool pin caps. (Pay
attention to the cut at the right side).
3. Thread both threads in the same way as for single threading.
4. After passing guide see 5 pull threads through each needle eye 6.
Note:
1. Twin needle cannot be threaded by the auto threader system.
2. Sewing width should not exceed 2/3 of the maximum stitch width, as
needles would break.
(Twin needle is not included in the standard accessories. It’s an optional
part).
5
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG NM 680 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG NM 680 in the language / languages: English, German as an attachment in your email.

The manual is 3,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info