464377
10
Zoom out
Zoom in
Previous page
1/24
Next page
10
2.3.2 Electrical connection
The ELFAMATIC G 3000 must be connected as shown in the
connection diagram on page 11.
It is especially important to note the following points:
1. If the outside temperature has a value which
corresponds to the E1 value of the central charging
controller, the ED signal of the respective charging
controller is 0 %, or 2 % if “EL” is set.
2. Z1/Z2 can be loaded up to max. 300 W.
3. The charging controller and the group control unit
ELFAMATIC G 3000 are also suitable for “single-wire
control”.
The “clocked” outer conductor is connected to
terminal Z1/A1.
4. If terminals KU1-KU2 are activated by means of a time
switch, there is a reduction of 35 %.
5. Phase coincidence between L and LF and between the
outer conductors of the charging controller as well as a
specific phase sequence are not necessary.
6. Position of the DIP switches inside the top part of the
housing
OFF OFF OFF
OFF OFF OFF
DIP 3
DIP 2
DIP 1
DIP 1 Input signal
OFF = 40 % ED
ON = 80 % ED
DIP 2 Output signal
OFF = 40 % ED
ON = 80 % ED
DIP 3 Electronic charging controller If switch is set to ON, DIP 1 and 2 do not function.
If an electronic charging controller is activated, the input and output signal is 2 to 80 %.
Preliminary check
The following checks must be performed at the base before the mains voltage is switched on
(housing with electronic components should not be plugged in):
Insulation test on all cables (without consumers)
Resistance test (turn the rotary knob on the storage heater clockwise as far as it will go)
An A1 and A2 of the ELFAMATIC G 3000:
R= 176 to 100 k
Switch on the mains voltage and measure between L and N.
Measure the clock signal between Z1 and Z2.
Switch off the mains voltage.
Attach the top part of the housing to the base.
This completes the preliminary check.
For the Fitter
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG ELFAMATIC G 3000 Individuele regelaar of versterker at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG ELFAMATIC G 3000 Individuele regelaar of versterker in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info