464377
9
Zoom out
Zoom in
Previous page
1/24
Next page
9
English
2. Installation instructions
2.1 Regulations and specifications
Installation and electrical connection must be performed by a specialist technician in compliance
with these installation instructions.
All electrical connection and installation work must be performed in accordance with the VDE
regulations (0100), specifications from the responsible power supply company and the relevant
national and regional regulations.
See the information and materials enclosed in the device packaging.
Observe the information on the device rating plate.
The specified voltage must be identical to the mains voltage.
2.2 Technical specifications
Supply voltage 200–230 V +10 % / -15 % AC 50/60 Hz
Power consumption 3.0 W
Terminal cross-section Max. 2.5 mm
2
Switching capacity 300 W
Fuse T 1.6 L 250 V
Ambient temperature range 0 °C to +50 °C
Degree of protection IP 20 (after installation)
Safety class II (total insulation)
Category II
Spare fuse
2.3 Installation
2.3.1 Controller
The ELFAMATIC G 3000 must be fitted in the bottom row of a distribution board, whereby a gap of
one SI circuit-breaker width must be provided at the sides.
Shock protection to safety class II is provided if the ELFAMATIC G 3000 is installed in
a small distribution board to DIN or
a distribution board to DIN
The ELFAMATIC G 3000 consists of a base with terminals
for rail mounting as well as the plug-in housing with the
electronic components.
The top part of the housing is removed from the base by
releasing the lower housing catch using a screwdriver and
then pulling off the top part.
The base must be de-energised before the top part of
the housing is mounted.
Replacing an existing ELFAMATIC G 2100
The device must be connected as shown in the circuit
diagram.
Removal
To remove the controller, release the top part from the
base (as described above) and disconnect the connecting
cables.
Then release the base from the rail as shown in the
illustration opposite.
ED
Aufladung
-36 % +12 %
ELFAMATIC G 3000
For the Fitter
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG ELFAMATIC G 3000 Individuele regelaar of versterker at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG ELFAMATIC G 3000 Individuele regelaar of versterker in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info