648332
25
Zoom out
Zoom in
Previous page
1/76
Next page
25
Installation – for qualied contractors
» Cleanly break out the knock-outs in the appli-
ance cover. Deburr the sharp edges with a le if
necessary.
» Slide the lower section of the back panel under the
tap connection pipes. Click the lower section of the
back panel into place.
» Secure the connection pipes to the appliance.
10.2.6 Operation with preheated water
You can limit the maximum inlet temperature by installing
a central thermostatic valve.
10.2.7 Temperature limit
CAUTION Burns
If operating with preheated water, the set tempera-
ture limit and anti-scalding protection may be inef-
fective.
» In this case, limit the temperature with an up-
stream central thermostatic valve.
You can set the temperature limit inside the appliance
cover to 43 °C.
6 0 °
C
4
3
°
C
D0000046203
» Push the set value transducer cable plug onto the
43 °C temperature limiter.
After enabling the temperature limit, you can only select
temperatures between 30 and 43 °C.
10.3 Completing the installation
» Open the shut-off valve in the twin connector or the
cold water inlet line.
11. Commissioning
WARNING Electrocution
Commissioning may only be carried out by a qual-
ied contractor in accordance with safety regula-
tions.
11.1 Initial start-up
2.
1.
L
L
3
L
3
4
L
2
1
L
1
2
MV
NT C
T- soll
X1 1
18
21
24
k
W
26_02_02_0769
» Open and close all connected draw-off valves sever-
al times, until all air has been vented from the pipe-
work and the appliance.
» Carry out a tightness check.
» Activate the safety pressure limiter by rmly pressing
in the reset button (safety pressure limiter disabled in
the delivered condition).
» Plug the temperature selector cable plug into the
PCB.
» Fit the appliance cover. The appliance cover must
audibly click into place. Check that the appliance
cover is seated correctly.
» Switch the mains power ON.
» Calibrate the temperature. Turn the temperature se-
lector fully clockwise then fully anti-clockwise.
» Check the function of the appliance.
Appliance handover
» Explain the functions of the appliance to the user.
Show the user how to operate the appliance.
» Make the user aware of potential dangers, especially
the risk of scalding.
» Hand over these instructions.
11.2 Recommissioning
» Vent the appliance and the cold water inlet line (see
chapter "Operation / Settings").
» See chapter "Installation / Installation / Commission-
ing / Initial start-up".
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG DDLE Basis 13 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG DDLE Basis 13 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 19,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info