603904
20
Zoom out
Zoom in
Previous page
1/28
Next page
20 www.aeg.com
5.4 Electrical connection
The electrical connection must be
carried out in accordance with the
current standards and laws in force.
Before connecting check that:
the system and electrical sockets
amperage is adequate for the
appliance maximum power (see
data label affixed on the back of the
cooker).
the socket or system has an effective
earth connection in accordance with
current standards and prescriptions
of the law. All responsibility is
disclaimed if this is not complied
with.
the plug and socket or the multipolar
switch must be accessible after
installation of the appliance.
When connecting to the mains with a
socket:
Fit to the power cable (if without) a
standardized plug, suitable for the
load which is indicated on the data
label. Connect the wires making sure
they correspond as shown below, and
remember that the earth wire must
be longer than the phase wires:
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol
(earth)
= green/yellow wire
The power cable must be laid so
that no parts of it ever reach a
temperature of 75 °C.
For connecting do not use, adapters
or shunts as they could cause false
contacts resulting in hazardous
overheating.
When connecting directly to the mains:
Install a multipolar switch that can
withstand the appliance load, with
a minimum opening between the
contacts of 3 mm. Remember that
the earth wire must not be cut out by
the switch.
Connecting the power cable
The all-electric cookers and some combi
versions are without supply cable and
are adjusted for single-phase power,
butt they can, with due modifications,
be powered by three phase systems by
following these instructions:
Remove the rear panel from the
cooker.
Move the connecting plates in the
terminal board fig.7, following the
diagram in fig. 8.
You will also find this diagram affixed
to the back of the cooker.(fig.9)
according to the type of connection
you want.
Connect the power cable, whose
cross section must be suitable
(see paragraph «TECHNICAL
FEATURES»), keeping the earth wire
longer than the phase wires.
Secure the cable in the clamp and -
fit the rear panel in place.
fig.7
  

fig. 8





    
 
fig. 9
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG 49190GO-MN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG 49190GO-MN in the language / languages: English as an attachment in your email.

The manual is 1,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of AEG 49190GO-MN

AEG 49190GO-MN User Manual - Dutch - 28 pages

AEG 49190GO-MN User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info