Manual Aduro 15-4 (page 23 of 47) (English, German, Danish, French, Swedish)

632343

Zoom out

Zoom in

1/47

_______________________________________________________________________________________________________________________________

Please note: that the Aduro 15-4 must be installed on a floor with the adequate load-bearing capacity. If the

existing construction does not meet this requirement, appropriate adaptation measures must be taken (e.g. a load-

distributing plate).

If the wood burning stove is to be placed close to flammable material, such as a wooden floor or carpet, it must be

placed on a non-flammable base. The floor plate should extend for at least 30 cm in front of the wood burning

stove, and 15 cm on each side.

2.2 Pipe connection

Aduro 15-4 leaves the factory with the flue outlet mounted on the top. If you require the flue outlet on the back,

remove the round circle from the rear cover and heat shield at the upper rear of the stove and then exchange the

exhaust connector (located on the top outlet above the stove) with the cover plate (that covers the rear outlet). The

top outlet is finished with the plate that lies in the ash drawer. A flue pipe with an internal diameter of 150 mm

should be used for Aduro stoves.

2.3 Connection to a brick chimney

If the stove is being connected to a brick chimney, the rear outlet should be used, or a curved flue pipe via the top

outlet. After measurement, a hole is made in the chimney in which the pipe sleeve is placed and fireplace mortar is

used to seal it in place. The stove is placed in position and the flue pipe is put in place. A thin gasket is placed

between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude 5–10 cm into the pipe

sleeve, but must not block the opening in the chimney (see the illustration below).

The wood burning stove can be connected to a chimney to which other heat sources are connected.

2.4 Safetywire

The stove comes with a safety wire. Following are step by step instructions how to mount the safety wire (see

below):

1. Mount the bracket on the wall central to the stove

For Aduro 15-4: ca. 60 cm above the floor hearth

2: Slide the safety wire through the two oblong holes in the backplate of the stove as well as through the eye in the

wall bracket. The safety wire ends must be secured in the rectangular wirelock.

3: The lenght of the wire is adjusted and the wirelock tightened. Excess wire is cut off. In case the wire should be

real tightened, the stove can temporarily be pushed slightly against the wall, while the wire is tightened.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Aduro 15-4 in the language / languages: English, German, Danish, French, Swedish as an attachment in your email.

The manual is 1,82 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Aduro 15-4 Manual

Product: