755224
9
Zoom out
Zoom in
Previous page
1/32
Next page
9
FSL wiring (DEOL)
Enables individual monitoring of a wire tamper (see
Installation Instructions).
Anti-masking wiring:
If the sensor has the anti-mask attribute, three resistors can
monitor all states (OK, alarm, tamper, masked). The zone
can be programmed just like any other zone (e.g. “Normal
Alarm”), but it must be given the “Masking” attribute.
Important: For wiring examples, see the Installation
Instructions.
3.) Bus input
Normally an 8 x 0.22mm² alarm cable is used. Use
screened cables in areas with interference frequencies (see
also Installation Instructions).
Important: The maximum distance to the furthest extension
must not exceed 1km.
Important: The voltage supply on the extensions must not
fall below 10.5V DC (recommendation: min. 12V). If the
voltage is too low, duplicate the voltage leads with
remaining cables or use an additional voltage supply.
The first extension to the bus is connected to the alarm
centre via the NODE NETWORK IN connector (bus input).
Each successive extension is connected to NODE
NETWORK OUT (bus output) of the previous extension.
4.) AUX error LED
Lights when the fuse blows.
5.) AUX connector
Additional voltage connector for supplying external sensors
and outputs.
6.) Power LED:
Blinkt, wenn die Kommunikation über den Bus gestört ist.
7.) Operating panel error
Lights when the fuse blows.
8.) Connecting operating panels (optional)
The voltage supply on the operating panels must not fall
below 10.5V DC (recommendation: min. 12V). If the voltage
is too low, duplicate the voltage leads with remaining cables
or use an additional voltage supply.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus Terxon LX - AZ4230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus Terxon LX - AZ4230 in the language / languages: English, German, Dutch, Danish, French, Italian as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info