755223
12
Zoom out
Zoom in
Previous page
1/38
Next page
12
5. Operation
The radio extension module can detect different errors and
faults in the radio components and transmit them to the alarm
centre.
5.1 Anzeige der Signalstärke
1. Put the extension module in learn mode.
2. Press “SELECT” until the desired zone number or radio
remote control number appears. Both LEDs on the PCB
must be off.
3. Activate the corresponding radio component. The green
LED (Pass) shows that the signal strength is sufficient.
The red LED (Fail) shows that the signal strength is not
sufficient. The display shows the signal strength and
the zone number alternatingly.
4. Repeat steps 2 and 3 to display the signal strength
again.
5.2 Jamming
A jamming signal is a signal of the same frequency as the radio
components that is strong enough to interfere with the radio
signal for at least 30 seconds a minute. Set the “Jamming”
jumper to activate this function and transmit a corresponding
message to the alarm centre.
5.3 Supervision
Set the “Supervision” jumper to activate this function. The radio
extension reports a sensor as faulty if it receives no signal from
this sensor within the programmed period.
5.4 Sensor low battery
This message is sent to the alarm centre when the battery
power of the radio sensor is low.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus Terxon LX - AZ4220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus Terxon LX - AZ4220 in the language / languages: English, German, Dutch, Danish, French, Italian as an attachment in your email.

The manual is 0,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info